WhatsBusted
3D model of a garbage disposal

Garbage disposal (continuous feed)

Garbage disposal repair, from the inside out

A garbage disposal has no blades. A spinning plate flings food against a grinding ring until it is small enough to wash away.

Most of the time a dead disposal is only jammed or tripped. See inside it in 3D, free a jam, and learn when the whole unit is due for a swap.

Parts

What is inside a garbage disposal

Tap a part to find it in the model.

  • Guide coming soon
  • Guide coming soon
  • Guide coming soon
  • Guide coming soon
  • Guide coming soon
  • Guide coming soon
  • Guide coming soon
  • Guide coming soon

How it works

How a garbage disposal works

A motor spins a plate. Two loose lugs on the plate throw food against a toothed ring.

  1. 1

    Food drops into the grinding chamber

    Scraps and running water fall through the sink flange into the chamber at the top of the unit.

  2. 2

    The flywheel flings it outward

    The motor spins a flat plate with two swinging lugs. They do not cut. They throw the food against the wall of the chamber.

  3. 3

    The grind ring shreds it

    The chamber wall is a ring of sharp slots. Food is ground against it until the pieces are small enough to pass through.

  4. 4

    Water carries it down the drain

    The slurry drops below the plate and washes out the discharge tube into your drain trap.

Model number

Where to find your model number

Look at the bottom of the unit, or on the lower side of the body, with a flashlight.

  • Note the horsepower as well as the model. It matters when you buy a replacement.

Safety first

Before you open a garbage disposal

  • Never put your hand in a disposal. Use tongs or pliers to remove anything from the chamber.
  • Unplug it, or turn off its breaker, before you work on it from below.
  • If the body of the unit itself is leaking from a crack or seam, it cannot be repaired. Replace it.

Read the full safety rules