How to clean an AC condenser coil
Grass clippings, leaves and dust on the outdoor coil make the whole system work harder. Power off, a soft brush and a garden hose fix it.
- Difficulty
- Anyone can do it
- Time
- 20–45 min
- Typical part cost
- $0Pro: $75–$230
- Tools
- 3See the list
Power off, brush, rinse. The only care points are not bending the fins and keeping water out of the electrical box.
What it does
What the condenser coil does
Hot refrigerant runs through the coil's tubing, and the thin aluminum fins around it pass the heat to the air the fan pulls through.
Anything that blocks that airflow, debris on the fins or plants and grass crowding the unit, slows the heat on its way out.
Why it fails
The coil does not wear out, it clogs: leaves, grass clippings, dust and dirt pack into the fins.
Cleaning cannot fix a refrigerant leak. Oily spots on the coil or a coil that stays cold and frosty point to a pro problem.
Symptoms
Signs of a bad condenser coil
Runs long, cools weakly
The AC runs and runs on hot days and the house never quite gets cool.
Full diagnosisFins matted with debris
Grass, leaves or a grey mat of dust on the outside of the coil, or plants crowding the unit.
How to test it
Test the condenser coil before you buy
- With the system off, walk around the unit and look at the fins through the grille.
- Check the ground around the unit for plants, tall grass or clutter crowding it.
- Good
- You can see daylight through clean fins, and the area around the unit is clear.
- Bad
- Debris or a mat of dirt covers the fins, or plants crowd the unit. Clean it (steps below).
Safety first
Before you touch anything
- 1
Thermostat off, disconnect out, breaker off
Turn the thermostat off, then cut the power at the outdoor disconnect and the AC breaker before you touch the unit. The fan can start without warning.
- 2
Water away from the electrics
Rinse only the coil, gently. Do not spray into the electrical access panel or the disconnect box, and never use a pressure washer.
Tools you'll need
Grab these first
Tool and part links are affiliate links. We may earn a commission at no extra cost to you, and it never changes what we tell you to check first. How this works
- Garden hoseA gentle rinse through the fins. Never a pressure washer.Typically $15–$35Shop this tool
- Stiff nylon brushBrushes debris off the fins without bending them.Typically $5–$12Shop this tool
- Shop vacuumOptionalPulls dry leaves and debris out from the base and between the fins.Typically $40–$90Shop this tool
- Work glovesFins and cabinet edges are sharp.Typically $8–$20Shop this tool
Step by step
How to clean the condenser coil
- 1
Shut it off
Set the thermostat to off. Pull the outdoor disconnect or switch it off, and turn off the AC breaker.
- 2
Clear around the unit
Pull weeds, trim back shrubs and rake away leaves and clippings from around the unit. Your owner's manual lists how much clear space it needs.
- 3
Brush the fins
Gently brush loose debris off the outside of the fins with a soft brush, working up and down along the fins rather than across them. A shop vacuum with a brush helps on dry debris.
- 4
Rinse gently
Rinse the coil lightly with a garden hose on a gentle setting, keeping the spray on the fins and away from the electrical panel. Never use a pressure washer: it flattens the fins.
- 5
Let it dry, then power up
Let the unit dry, then turn the breaker on, reinsert the disconnect and set the thermostat to cool.
Buy the part
Get the right replacement
Buy the part
Condenser coil
Opens Amazon in a new tab. Where’s my model number?
What to look for
- Nothing is required. A soft brush and a garden hose do the job.
- A fin comb sized to your coil's fins per inch can straighten small patches of bent fins.
Know your limits
When to call a pro
Stop and call a pro if
- You see oily spots on the coil or the refrigerant lines. That can mean a leak.
- Large areas of fins are flattened, or the coil is damaged or corroded.
- The coil is clean, the fan runs, and the house still does not cool.
- The lines or the outdoor unit are covered in frost or ice.
FAQ
Condenser coil questions
How often should I clean the outdoor coil?
Look at it before the cooling season and whenever leaves or grass pile up around it. Clean it when you see debris on the fins.
Can I use a coil cleaner spray?
Follow your manufacturer's advice. Plain water and a soft brush are usually enough for an outdoor coil, and harsh chemicals can damage the fins.
Do I need to take the top off to clean it?
Not for a normal cleaning. Brushing and rinsing from the outside, with the power off, is what manufacturers describe for owners. Taking the top off means lifting the fan motor and is best left to a tune-up.
Related
Keep going
- SymptomAC running but not coolingIf the indoor fan blows but the air is warm, look at the outdoor unit. A fan that will not spin, a hum with nothing turning, or a coil packed with debris all stop the cooling. Ice on the lines points to a dirty filter first, and to low refrigerant if the filter is clean.Open guide
- AC condenser partCondenser fan motorThe fan motor on top of the outdoor unit spins the blade that pulls air through the coil. When it fails, heat builds up, cooling stops and the compressor overheats. It hangs from the top grille, with a blade, a few bolts and a few wires.Open guide
- AC condenser partRefrigerant lines and chargeTwo copper lines connect the outdoor unit to the indoor coil, and the refrigerant inside them carries the heat out of your house. A leak in the lines or either coil leaves the system low on charge. Checking, adding or recovering refrigerant takes an EPA-certified technician.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy