Dishwasher door gasket: clean and replace
Drips from the door are often just a dirty seal. If it is torn or flattened, a new one presses into its groove by hand in about fifteen minutes.
- Difficulty
- Anyone can do it
- Time
- 10–25 min
- Typical part cost
- $40–$100Pro: $50–$150
- Tools
- 1See the list
No tools on most models. The new gasket presses into the groove by hand.
What it does
What the gasket does
A rubber gasket runs around the top and sides of the tub opening, pushed into a groove. The door presses against it when it closes.
Many dishwashers also have a separate seal along the bottom of the door.
Why it fails
Food and grease build up on the gasket, so it does not seal fully.
Rubber hardens, flattens and cracks with age and heat.
A gasket pulled out of its groove, or twisted, leaves a gap.
Symptoms
Signs of a bad gasket
Drips from the door
Water on the floor in front of the dishwasher during or after a cycle.
Full diagnosisTorn, flat or brittle rubber
Run your finger along the gasket. Tears, flat spots and hard rubber all leak.
Gasket out of its groove
A section hangs loose or is twisted.
How to test it
Test the gasket before you buy
- Wipe the gasket all the way around with a damp cloth and a little dish soap.
- Look for tears, flat spots and places where it has pulled out of the groove. Check the bottom door seal too, if there is one.
- Good
- Soft, whole and fully seated. A clean gasket may have fixed the drip.
- Bad
- Torn, flat, brittle or will not stay seated. Replace it.
Safety first
Before you touch anything
- 1
Switch it off
Switch off the breaker, or unplug the dishwasher, and let it cool before you work around the door.
Tools you'll need
Grab these first
Tool and part links are affiliate links. We may earn a commission at no extra cost to you, and it never changes what we tell you to check first. How this works
- Stiff nylon brushCleans food out of the gasket and its groove.Typically $5–$12Shop this tool
- Putty knifeStiff, 1-1/2 in.OptionalA dull plastic edge helps press the gasket into its groove.Typically $5–$12Shop this tool
Step by step
How to replace the gasket
- 1
Switch off and open the door
Switch off the breaker, or unplug the dishwasher, and open the door fully.
- 2
Pull out the old gasket
Grab the gasket at one end and pull it straight out of its groove. On most models it is just pressed in.
- 3
Clean the groove
Wipe out the groove and pick out any bits of old rubber, so the new gasket seats all the way.
- 4
Press in the new gasket
Find the middle of the new gasket and press it into the top center of the groove. Work outward toward each side.
Do not stretch or twist it as you go. Push it all the way in.
Tip. If the new gasket is kinked from the box, soak it in warm water for about ten minutes. It gets softer and easier to seat.
Buy the part
Door gasket
Opens Amazon in a new tab. Where’s my model number?
What to look for
- The gasket listed for your dishwasher's model number.
- Whether you need the tub gasket, the bottom door seal, or both.
- 5
Test it
Close the door, switch on and run a short cycle. Check the floor in front of the door afterward.
Buy the part
Get the right replacement
Buy the part
Door gasket
Opens Amazon in a new tab. Where’s my model number?
What to look for
- The gasket listed for your dishwasher's model number.
- Whether you need the tub gasket, the bottom door seal, or both.
Know your limits
When to call a pro
Stop and call a pro if
- The new gasket does not stop the leak. The door may not be closing evenly, or the leak is coming from below.
- Water is leaking from under the dishwasher, not the door. See dishwasher leaking.
FAQ
Door gasket questions
How do I stop my dishwasher leaking from the door?
Clean the gasket, check the dishwasher is level, and use only dishwasher detergent. If the gasket is damaged, replace it.
Can I glue a gasket that keeps falling out?
It is not made to be glued. The gasket presses into its groove. If it will not stay, it has stretched or is the wrong part. Replace it.
Does regular dish soap cause leaks?
Yes. Hand dish soap foams far too much in a dishwasher and can push suds out of the door. Use only dishwasher detergent.
Related
Keep going
- SymptomDishwasher leaking waterWater on the floor in front of or under the dishwasher. The wrong soap, a dirty or worn door gasket, or a loose hose or valve connection causes most leaks.Open guide
- Dishwasher partDoor latch and switchThe door latch holds the door shut and closes a switch that lets the dishwasher run. A broken latch or a worn switch means it will not start. Test it and swap it from inside the door.Open guide
- Dishwasher partSpray armsThe spray arms spin and throw water across the dishes. When their holes clog or an arm cracks, dishes in that area stay dirty. Pull them off, clear the holes, or swap a damaged arm.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
