Dishwasher won't start
Check the power, the settings and the door before anything else. Many dead dishwashers are locked, delayed or just not quite latched.
Check these first
Five-minute checks, no tools
Breaker and switch
Check the dishwasher's breaker, and the wall switch near the sink if yours has one.
Child lock and delay start
A control lock or delay start can make it look dead. Check the display and your manual.
Door fully latched
Close it firmly until it clicks. Check no rack or dish stops it shutting. A lower rack put in backward can stop it latching.
Power reset
Turn the breaker off for about a minute and back on. It clears many control glitches.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Door latch or switch
The latch does not catch, or its switch does not close. Lights on, no start.
Fix the door latch20–45 min$20–$80 - 2DIY fix
No power
A tripped breaker, a switch turned off, or a loose plug. Nothing lights up.
- 3DIY fix
Child lock or delay start
A setting is blocking the start. Clear it as your manual shows.
- 4DIY fix
Control board
Power and latch check out, settings are clear, and it still will not run.
Fix the control board30 min–1 hr$100–$300
What's happening
What your dishwasher is doing
To start, a dishwasher needs power from its breaker or under-sink outlet, a Start it accepts, and a door it can tell is latched.
The door latch closes a switch when the door shuts. Without that signal, the dishwasher will not fill or wash.
If nothing lights up at all, look at the power first: the breaker, the wall switch some homes have for the dishwasher, or the plug.
Know your limits
When to call a pro
Stop and call a pro if
- The breaker trips again as soon as you reset it.
- You smell burning or see scorch marks.
- Power is there, the latch tests good, and it still will not start.
FAQ
Common questions
Why does my dishwasher light up but not start?
Most often the door is not latched or the latch switch has failed. A child lock or delay start is the other common cause. See the door latch guide.
Does a dishwasher have its own breaker?
Often, yes. Check the labels in your breaker panel. Some homes also have a wall switch that controls it.
Can I reset a dishwasher?
Turn the breaker off, or unplug it, for about a minute and back on. Your manual may also show a cancel or reset button sequence.
Related
Keep going
- SymptomDishwasher won't fill with waterYou hear the cycle start but no water comes in. A closed shutoff, a stuck float, or a failed inlet valve causes most of it. The latch and the control come next.Open guide
- Dishwasher partDoor latch and switchThe door latch holds the door shut and closes a switch that lets the dishwasher run. A broken latch or a worn switch means it will not start. Test it and swap it from inside the door.Open guide
- Dishwasher partControl boardThe control board runs every step of the cycle and powers the valve, pumps and heater. It fails less often than the parts around it. When it is the cause, swap it inside the door.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
