Dishwasher won't fill with water
Check the shutoff under the sink and the float in the tub before anything else. Then it is usually the inlet valve.
Check these first
Five-minute checks, no tools
Shutoff under the sink
Make sure the valve on the hot water line under the sink is fully open.
Free the float
Lift the float in the tub floor and let it drop. It should move freely. Clean around it.
Door latched
Close the door firmly until it clicks. Check no rack or utensil stops it latching.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Inlet valve
The coil has burned out or the screen is clogged. No water comes in.
Fix the inlet valve30 min–1 hr$20–$70 - 2DIY fix
Water shut off
The shutoff under the sink is closed or partly closed.
- 3DIY fix
Stuck float or bad float switch
The float is stuck up, or its switch has failed.
Fix the float switch10–45 min$10–$45 - 4DIY fix
Door latch
The latch switch does not close, so the fill never starts.
Fix the door latch20–45 min$20–$80 - 5DIY fix
Control board
The valve tests good and gets no power.
Fix the control board30 min–1 hr$100–$300
What's happening
What your dishwasher is doing
When a fill starts, the control powers the inlet valve and hot water flows in from the shutoff under the sink.
A float in the tub floor rises with the water and can stop the fill. If it is stuck up, the dishwasher thinks it is already full.
The door latch also has to be closed. Without it, the dishwasher will not fill.
Know your limits
When to call a pro
Stop and call a pro if
- The shutoff under the sink will not open or is leaking. Call a plumber.
- Valve, float and latch all check out and it still will not fill.
FAQ
Common questions
Why is my dishwasher not getting water?
Check the shutoff, free the float, then test the inlet valve. Those three cover most cases.
How much water should a dishwasher use?
Less than you might think. It fills only the bottom of the tub and sprays that water around again and again, so a shallow pool is normal.
Can a stuck float stop the fill?
Yes. A float stuck up tells the dishwasher it is already full. See the float switch guide.
Related
Keep going
- SymptomDishwasher won't startNothing happens, or the lights come on but it will not run. Power, a child lock or delay start, and the door latch cause most of it. The control board is last.Open guide
- SymptomDishwasher not cleaning dishesDishes come out gritty, filmy or with food still on them. A clogged filter or spray arms cause most of it. Low water, cool water, or a weak wash pump are next.Open guide
- Dishwasher partWater inlet valveThe inlet valve lets hot water into the dishwasher for each fill. A clogged screen or a dead coil means no fill. A leaking seal means water when it is off. Test it and swap it from the front.Open guide
- Dishwasher partFloat and float switchThe float in the tub floor rises with the water and trips a switch to stop an overfill. A stuck float stops the fill. A bad switch can stop the fill or let it overfill. Clean it, test it and replace it.Open guide
- Dishwasher partDoor latch and switchThe door latch holds the door shut and closes a switch that lets the dishwasher run. A broken latch or a worn switch means it will not start. Test it and swap it from inside the door.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
