WhatsBusted
3D model of a dishwasher
Symptom

Dishwasher not cleaning dishes

Before you buy a single part, clean the filter and the spray arms. Those two free jobs fix most dirty-dish complaints.

Check these first

Five-minute checks, no tools

  • Clean the filter

    Switch the dishwasher off. Twist out the filter in the tub floor, rinse it under warm water with a soft brush, and lock it back in.

  • Clear the spray arms

    Spin each arm by hand, then take them off and clear the holes with a toothpick.

  • Run the sink hot first

    Run the kitchen tap until the water is hot before you start the dishwasher, so it fills with hot water from the start.

  • Load so water can reach

    Nothing tall in the way of the arms, dirty sides facing down and toward the center, and nothing nested together.

Likely causes

Ranked by how often they are the problem

  1. 1

    Clogged filter

    DIY fix

    Food packed in the mesh starves the arms and puts grit back on the dishes.

    Fix the filter5–15 min$5–$50
  2. 2

    Clogged or stuck spray arms

    DIY fix

    Blocked holes or an arm that cannot turn leaves whole areas of the rack dirty.

    Fix the spray arms10–45 min$30–$100
  3. 3

    Not enough water

    DIY fix

    A clogged inlet screen or weak valve leaves the tub too low to wash well.

    Fix the inlet valve30 min–1 hr$20–$70
  4. 4

    Water not hot enough

    DIY fix

    A dead heating element, or a long run of cold water to the dishwasher, leaves grease on dishes.

    Fix the heating element30 min–1.5 hr$40–$80
  5. 5

    Weak or failed wash pump

    DIY fix

    It fills but you hear little or no wash sound, or a hum or grind.

    Fix the wash pump1 hr–2.5 hr$80–$200

What's happening

What your dishwasher is doing

A dishwasher cleans by spraying a small amount of hot, soapy water hard and often. Water goes up through the spray arms, falls back through the filter, and goes around again.

Anything that slows that loop shows on the dishes: a packed filter, clogged arm holes, or an arm that cannot turn.

If the loop is clear, the water itself may be the problem: not enough of it from the inlet valve, not hot enough, or not pushed hard enough by the wash pump.

Know your limits

When to call a pro

Stop and call a pro if

  • Filter and arms are clean, it fills, and there is no wash sound or a loud grind. The wash pump likely needs replacing.
  • Hot water at the sink is fine, the element tests good, and the water never gets warm. The control may be at fault.

FAQ

Common questions

Why are my glasses cloudy?

Often a hard water film. Rinse aid and the right amount of detergent help. If a little vinegar will not rub it off, it may be etching, which is permanent. Grit and food on them point to the filter and the arms instead.

Should I rinse dishes before loading?

Scrape off the big scraps. Heavy pre-rinsing is not needed on most dishwashers, as long as you clean the filter regularly.

Does the detergent matter?

Yes. Old or clumped detergent cleans poorly. Use fresh dishwasher detergent in the amount your manual calls for.

Related

Keep going

Get the next fix before it breaks

A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.

We send it with Kit. Privacy