Dishwasher won't drain
Standing water in the bottom is usually a clog, not a broken part. Work from the filter, to the sink, to the pump.
Check these first
Five-minute checks, no tools
Clean the filter
Switch off the breaker, then sponge out the water, twist out the filter and rinse it. Look in the sump below for glass or seeds.
Run the disposal
If the dishwasher drains into a disposal, run the disposal with water to clear it, then try a drain.
Check the hose and loop
Under the sink, look for a kinked hose and check it loops up high or goes to an air gap.
Reset and drain
Switch the breaker off for a minute, back on, then start and cancel a cycle so it drains.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Clogged filter
A packed filter slows the water getting to the pump.
Fix the filter5–15 min$5–$50 - 2DIY fix
Clogged disposal, hose or air gap
A clogged disposal, a kinked hose or a blocked air gap stops the water leaving.
Fix the drain hose15–45 min$10–$50 - 3DIY fix
Disposal knockout plug
A new disposal still has its plastic plug in the dishwasher inlet. It has never drained right.
Fix the drain hose15–45 min$10–$50 - 4DIY fix
Jammed or failed drain pump
Debris jams the impeller, or the motor burns out. Hum or silence at drain time.
Fix the drain pump30 min–1.5 hr$50–$150 - 5DIY fix
Control board
The pump tests good and never gets power.
Fix the control board30 min–1 hr$100–$300
What's happening
What your dishwasher is doing
At the end of each wash, the drain pump pushes water up the drain hose, over a high loop or through an air gap, and into the disposal or the sink drain.
A clog anywhere on that path leaves water behind: the filter in the tub floor, the hose, the air gap, or the disposal it drains into.
If this started right after a new disposal was installed, the knockout plug in its dishwasher inlet was probably never removed.
Know your limits
When to call a pro
Stop and call a pro if
- The kitchen sink also drains slowly or backs up. The house drain is clogged. Call a plumber.
- Filter, hose, disposal and pump all check out and it still will not drain.
FAQ
Common questions
Is a little water in the bottom normal?
A small amount in the filter area is normal on many models. It keeps the seals from drying out. Water covering the tub floor after a cycle is not.
Why does my new dishwasher not drain?
Most often a kinked hose, no high loop, or a disposal knockout plug left in place. See the drain hose guide.
How do I get the standing water out?
Switch off the breaker, then bail it with a cup and soak up the rest with a sponge or towels.
Related
Keep going
- SymptomDishwasher not cleaning dishesDishes come out gritty, filmy or with food still on them. A clogged filter or spray arms cause most of it. Low water, cool water, or a weak wash pump are next.Open guide
- SymptomDishwasher leaking waterWater on the floor in front of or under the dishwasher. The wrong soap, a dirty or worn door gasket, or a loose hose or valve connection causes most leaks.Open guide
- Dishwasher partDishwasher filterMost dishwashers have a filter in the tub floor that catches food before the water goes around again. A clogged one leaves dishes dirty and the tub smelling. Twist it out, rinse it, twist it back.Open guide
- Dishwasher partDrain hose, high loop and air gapThe drain hose carries water from the drain pump to the disposal or sink drain, over a high loop or through an air gap. A kink, a clog, a missing loop or a disposal knockout plug stops it. Check and clear it.Open guide
- Dishwasher partDrain pumpThe drain pump pushes dirty water out the drain hose at the end of each wash. When it jams or burns out, water stays in the tub. Test it, then swap it from the front or from underneath.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
