WhatsBusted

3D model in the works

Dishwasher filter

Most common failureAlso called dishwasher filter cleaning, ultra fine filter

How to clean a dishwasher filter

Good news: if your dishes come out gritty or the tub smells, this ten-minute, no-tools job fixes it more often than anything else.

Difficulty
Anyone can do it
Time
5–15 min
Typical part cost
$5–$50Pro: $50–$130

Pull out the rack, twist, lift, rinse. No tools.

What it does

What the filter does

The filter sits in the floor of the tub, under the lower spray arm. Water drains back through it after spraying the dishes, and it holds back food so the pump does not throw it back at your plates.

On many dishwashers it comes in two parts: a cylinder you twist out, and a flat mesh plate underneath it.

Some older dishwashers use a self-cleaning grinder instead and have no filter to remove. If nothing twists or lifts out, check your manual and do not force it.

Why it fails

Food, grease, labels and glass chips build up until water cannot pass through fast enough. The spray gets weak and grit ends up on the dishes.

Food left sitting in the filter between washes starts to smell.

A cracked or torn filter lets debris through to the pump and the spray arms.

Symptoms

Signs of a bad filter

  • Gritty or spotted dishes

    Food specks and a gritty film on dishes, especially glasses and the top rack.

    Full diagnosis
  • Bad smell

    A sour smell from the tub between washes.

  • Water left in the bottom

    A packed filter can slow the drain enough to leave water behind.

    Full diagnosis

How to test it

Test the filter before you buy

Look at the filterNo meter needed
  1. Switch off the breaker, or unplug the dishwasher. Pull the lower rack all the way out.
  2. Find the filter in the tub floor, under or beside the lower spray arm.
  3. Look for food packed in the mesh, a greasy film, or a crack.
Good
Clean mesh with no cracks. Look at the spray arms next.
Bad
Packed or greasy. Clean it. Cracked or torn. Replace it.

Safety first

Before you touch anything

  1. 1

    Switch it off

    Switch off the dishwasher's breaker, or unplug it under the sink, and let it cool. If it just ran, the tub floor and water can be hot.

Tools you'll need

Grab these first

Tool and part links are affiliate links. We may earn a commission at no extra cost to you, and it never changes what we tell you to check first. How this works

See the full repair tool kit

Step by step

How to clean the filter

  1. 1

    Switch off and pull the rack

    Switch off the dishwasher's breaker, or unplug it under the sink, and let it cool. Pull the lower rack all the way out, or lift it out.

  2. 2

    Twist out the filter

    Grip the cylinder and turn it counterclockwise about a quarter turn until it unlocks. Lift it straight up.

    If there is a flat mesh plate under it, lift that out too. On some models a spray arm or a couple of locking posts have to come off first. Your manual shows how.

  3. 3

    Rinse and scrub

    Rinse both parts under warm running water. Scrub the mesh gently with a soft brush and a drop of dish soap.

    Do not use a wire brush or scouring pad. They can tear the mesh.

  4. 4

    Wipe the sump

    Wipe out the opening the filter sits in, and pick out any glass, bones or seeds. Do not push anything down into the pump.

  5. 5

    Lock it back in

    Set the flat plate back in place first. Drop the cylinder in and turn it clockwise until it locks, with any arrows lined up.

    A filter that is not locked down lets food straight into the pump.

  6. Buy the part

    Dishwasher filter

    Opens Amazon in a new tab. Where’s my model number?

    What to look for

    • The filter listed for your dishwasher's model number.
    • Both parts if both are damaged: the cylinder and the flat mesh.
  7. 6

    Rack in and run it

    Slide the rack back in. Switch the power on and run a normal cycle.

Buy the part

Get the right replacement

Buy the part

Dishwasher filter

Opens Amazon in a new tab. Where’s my model number?

What to look for

  • The filter listed for your dishwasher's model number.
  • Both parts if both are damaged: the cylinder and the flat mesh.

Know your limits

When to call a pro

Stop and call a pro if

  • The filter is clean, the spray arms turn, and dishes still come out dirty with little wash noise. The wash pump may be failing.
  • Glass or a hard object fell past the filter into the pump.

FAQ

Dishwasher filter questions

How often should I clean the dishwasher filter?

Many guides suggest about once a month. Do it more often if you run it every day, run greasy loads, or do not scrape plates.

My dishwasher has no filter I can find. Is that normal?

Some older models use a self-cleaning grinder instead. If nothing twists or lifts out, check your manual and do not force anything.

Is it bad to skip pre-rinsing?

Scraping off big scraps is enough for most dishwashers. Just clean the filter regularly, because it catches what you leave on.

Related

Keep going

Get the next fix before it breaks

A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.

We send it with Kit. Privacy