Garbage disposal leaking from the side: fix the discharge elbow
A drip from the pipe on the side of the disposal is usually a worn rubber gasket or a loose joint. A cheap part and about half an hour.
- Difficulty
- Anyone can do it
- Time
- 15–30 min
- Typical part cost
- $3–$25Pro: $80–$180
- Tools
- 3See the list
A couple of bolts or a clamp, and a slip nut. Keep a bucket under it.
What it does
What the discharge elbow does
The discharge elbow is the bent tube on the side of the disposal. One end fits into the disposal over a rubber gasket, held by a flange and bolts on many units or a clamp on others. The other end goes into the drain trap with a slip nut.
Why it fails
The rubber gasket at the disposal end hardens or flattens, and water seeps past it.
The bolts or clamp that hold the elbow work loose.
The slip nut at the trap end loosens, or the tube is not pushed far enough into the trap.
Symptoms
Signs of a bad discharge elbow
Drips at the side outlet
Water appears where the elbow meets the disposal, or where it meets the trap.
Full diagnosisLoose elbow
The elbow wiggles at the disposal.
How to test it
Test the discharge elbow before you buy
- Dry everything under the sink. Run water with the disposal on for a few seconds, then off.
- Watch the elbow with a light. Note whether water appears at the disposal end or the trap end.
- Good
- Disposal end: tighten the bolts or clamp, then replace the gasket if it still drips. Trap end: tighten the slip nut.
- Bad
- Water is coming from the disposal body or the bottom. That is not the elbow. See [replace the disposal](/garbage-disposal/whole-unit).
Safety first
Before you touch anything
- 1
Switch off and unplug
Turn the wall switch off and unplug the disposal, or switch off its breaker.
Tools you'll need
Grab these first
Tool and part links are affiliate links. We may earn a commission at no extra cost to you, and it never changes what we tell you to check first. How this works
- Multi-bit screwdriverPhillips, flat, squareRemoves the bolts or clamp that hold the elbow on.Typically $10–$25Shop this tool
- Tongue-and-groove pliers10 in.Loosens and tightens the slip nut at the trap.Typically $12–$28Shop this tool
- Bucket5 galCatches the water in the trap.Typically $4–$10Shop this tool
Step by step
How to replace the discharge elbow
- 1
Power off
Turn off the wall switch and unplug the disposal, or switch off its breaker.
- 2
Loosen the trap end
Put the bucket under the trap. Loosen the slip nut where the elbow enters the trap with channel-lock pliers.
- 3
Remove the elbow
Remove the bolts or clamp that hold the elbow to the disposal, and pull the elbow out of the trap and off the disposal.
- 4
Fit a new gasket
Pull off the old rubber gasket and clean both faces. Fit the new gasket on the elbow flange.
Buy the part
Discharge elbow and gasket
Opens Amazon in a new tab. Where’s my model number?
What to look for
- A gasket or elbow kit made for your disposal's brand and model. The fitting shape varies.
- 5
Reattach and test
Fit the elbow back on and tighten its bolts or clamp evenly. Push the other end into the trap and tighten the slip nut by hand, then about a half turn more with pliers.
Power on, run water with the disposal on, and check for drips.
Buy the part
Get the right replacement
Buy the part
Discharge elbow and gasket
Opens Amazon in a new tab. Where’s my model number?
What to look for
- A gasket or elbow kit made for your disposal's brand and model. The fitting shape varies.
Know your limits
When to call a pro
Stop and call a pro if
- The trap or drain pipe itself is cracked or corroded. Call a plumber.
- Water is coming from the disposal body. The unit needs replacing.
FAQ
Discharge elbow and gasket questions
Why is my disposal leaking from the side?
Usually the gasket where the discharge elbow bolts on, or the slip nut at the trap. Both are cheap fixes.
Can I use thread tape on the slip nut?
No. Slip joints seal with a plastic or rubber washer, not tape. Replace the washer if it is cracked, and check the pipes line up straight.
Is a leak from the side ever the dishwasher hose?
Yes. The dishwasher inlet is on the side too. See the dishwasher inlet guide.
Related
Keep going
- SymptomGarbage disposal leakingWater under the sink, traced to the disposal. Top leaks are the sink flange. Side leaks are the discharge elbow or the dishwasher hose. Bottom leaks mean the unit has failed inside.Open guide
- Garbage disposal partDishwasher inlet and knockout plugDisposals have a small inlet on the side for the dishwasher drain hose. New units ship with a plastic plug inside it. Remove the plug, fish it out, and clamp the hose on tight.Open guide
- Garbage disposal partSink flange and mounting ringThe sink flange is the metal drain ring in the sink. Plumber's putty seals it, and the mounting ring underneath clamps it and holds the disposal. When the putty dries out or the bolts loosen, it leaks from the top.Open guide
- Garbage disposal partWhole disposal unitWhen the body cracks, it leaks from the bottom or the reset button, or the motor is dead, the disposal gets replaced as a unit. Unhook it, move the cord, hang the new one and reconnect the drains.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
