Electric stove burner not heating
Electric coil ranges only. One burner cold and the rest fine? A two-minute swap test tells you whether it is the coil or something behind it.
Check these first
Five-minute checks, no tools
Breaker fully on
If several burners or the oven stopped too, switch the range's breaker fully off and back on.
Coil pushed fully in
With the knob off and the coil cool, lift it, pull it out and push it firmly back into its receptacle.
Swap test
Plug a working coil of the same size into the cold spot. If it heats, replace the original coil.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Coil element
A good coil heats in the same spot, or the coil reads open (OL) on a meter.
Fix the surface element5–30 min$40–$80 - 2DIY fix
Element receptacle
The terminals in the receptacle are scorched, pitted or loose, or the burner sparks or cuts in and out.
Fix the surface element5–30 min$40–$80 - 3DIY fix
Infinite switch
A good coil and a clean receptacle, but no heat in that spot. Or the burner stays red hot on every setting.
Fix the infinite switch30 min–1 hr$20–$120
What's happening
What your range is doing
Each coil plugs into a receptacle under its drip bowl. The switch behind the knob sends it 240 V, cycling on and off for lower settings.
When one burner stays cold, swap in a working coil of the same size. If the good coil heats in that spot, the original coil is bad. If it does not, look at the receptacle for scorching, then the switch.
If all the burners and the oven stopped at once, check the breaker first. Electric ranges need both halves of a double breaker.
Know your limits
When to call a pro
Stop and call a pro if
- The wiring under the cooktop is burned or melted.
- A good coil, receptacle and switch still give no heat.
- The breaker trips when you turn on that burner.
FAQ
Common questions
Does this work for glass cooktops?
No. Glass cooktops have radiant elements fixed under the glass, which you cannot swap-test. This page covers plug-in coil elements.
Why does my new coil cycle off on high?
Coils with a built-in limiter, common since 2019, cut power briefly to keep the pan from overheating. Short off periods are normal on those.
Can I use a burner that sparks or cuts in and out?
No. Sparking means a loose or burned connection. Turn it off and replace the receptacle and, if its prongs are pitted, the coil.
Related
Keep going
- SymptomOven not heatingThe oven will not heat, or barely warms. On an electric range the bake element is the usual cause, after the breaker. On a gas range a weak igniter is the most likely, after the gas supply. The sensor and the control come later.Open guide
- Range partCoil surface elementElectric coil ranges only. Each coil element plugs into a receptacle under its drip bowl. A dead coil, a burned receptacle or a failed switch all leave one burner cold. The coil itself just unplugs.Open guide
- Range partInfinite switchElectric coil ranges only. The infinite switch behind each knob cycles power to one surface element to give you low through high. When its contacts stick or burn, the element stays off, stays on full, or will not hold a setting.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
