Air handler refrigerant lines: leaks, frozen lines and when to call a pro
Two copper lines tie the air handler to the outdoor unit. If the big one is iced or the house will not cool, you can thaw it safely. Anything that opens those lines is certified work.
- Who fixes it
- A licensed pro
- Typical pro cost
- $250–$1,600
- Typical leak repair and recharge. Line leaks are usually at the low end
Refrigerant work. Finding the leak, repairing a joint or line, pressure testing, pulling a vacuum and recharging takes EPA Section 608 certification, brazing gear and gauges.
What it does
What the refrigerant lines does
Refrigerant flows in a sealed loop between the indoor coil and the outdoor unit through two lines. The larger one, the suction line, is insulated. The smaller one is the liquid line.
At the air handler the lines join the coil's copper stubs. On most central systems those joints are brazed. Ductless and some other systems use flare nuts instead.
The suction line runs cold when the system cools. Its foam insulation keeps it from sweating and dripping.
Why it fails
Joints and fittings can leak, and lines can be crushed, kinked or rubbed through. A leak leaves the system low on refrigerant.
Low refrigerant can make the coil and the suction line ice up. A clogged filter causes the same ice, and it is far more common, so check it first.
Insulation breaks down, especially outdoors in the sun, until it crumbles away. The bare suction line then sweats, drips or frosts.
Symptoms
Signs the refrigerant lines is failing
Ice on the big copper line
Frost or ice on the suction line where it enters the air handler, or at the outdoor unit, after the filter has been checked.
Full diagnosisRuns longer, cools less
The system runs and runs, the filter and vents are fine, and the house does not get as cool as it used to.
Oily spots or a hiss
Oily residue at a joint or fitting, or a hissing sound along the lines, points to a refrigerant leak.
Sweating or dripping lines
Water drips from the lines, or the insulation is torn, crumbling or missing. That is an insulation problem, not a leak, but it can cause water damage.
Safety first
Stay safe until it is fixed
- 1
Iced up? Cooling off, fan on
Turn the system off at the thermostat and set the fan to On to thaw the coil and lines. Do not chip the ice off, and do not run the cooling to melt it.
- 2
Do not open or top up the lines
Federal rules prohibit knowingly releasing refrigerant and require an EPA-certified technician to open the lines, add refrigerant or remove it. Do not loosen a fitting or flare nut.
What a pro does
What to expect from the service call
- Rule out the filter, the coil and the airflow first, since they freeze the lines the same way.
- Connect gauges and measure the system's pressures and temperatures to judge the charge.
- Find the leak with a detector or bubbles, then repair the joint, flare or line, brazing with nitrogen flowing through the copper.
- Pressure test the repair with nitrogen, pull a vacuum, and recharge to the manufacturer's specification.
- Replace damaged insulation with new closed-cell foam along the whole suction line, protected from the sun where it runs outdoors.
Know your limits
When to call a pro
Stop and call a pro if
- Ice comes back on the lines with a clean filter.
- You see oily spots on a joint or fitting, or hear a hiss.
- A line is crushed, kinked or cut, or its insulation is torn away.
- Anyone suggests adding refrigerant without finding the leak.
FAQ
Refrigerant lines questions
Why is there ice on the copper line at my air handler?
Usually because not enough air crosses the coil: a clogged filter, a dirty coil or blocked vents. Low refrigerant does it too. Turn the cooling off, run the fan to thaw it, and change the filter. If the ice comes back, call a technician.
Can I recharge the refrigerant myself?
No. Adding refrigerant takes EPA Section 608 certification, and a system that is low has a leak that needs fixing, not just topping up.
My refrigerant lines are dripping water. Is that a leak?
Usually not. The suction line runs below the dew point when it cools, so any gap in its insulation sweats. Have the insulation replaced. A refrigerant leak shows as weaker cooling, ice, a hiss or oily spots instead.
Related
Keep going
- SymptomAir handler coil frozen: ice on the evaporator coil or linesThe indoor coil has iced over, so little or no cool air reaches the vents. Turn the system off or to fan only and let it thaw. Then check the filter, the return grilles and the blower. If it keeps freezing, low refrigerant is a job for a certified pro.Open guide
- SymptomWater in the air handler drain pan: pan full or system shut offWater is backing up in the drain pan under the coil, or in the pan under the unit, and the system may have shut itself off. A clogged condensate drain is the usual cause. A stuck float switch, a coil that froze and melted, or a cracked pan are the others.Open guide
- Air handler partEvaporator coilThe evaporator coil is the A-shaped coil of refrigerant tubing and thin fins inside the air handler. House air passes through it to be cooled. A dirty coil chokes the airflow, ice blocks it, and a leak leaves the system low on refrigerant. Coil service is pro work.Open guide
- Air handler partAir filterFor heat pump and central air handlers, including units with electric heat strips. The filter cleans the air before it reaches the blower and coil. A clogged one chokes airflow, which can freeze the coil in summer and trip the heat strips in winter. Check it monthly.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
