Ice on your air handler's coil
Frost on the coil or the copper lines means the coil is running too cold. Turn the cooling off, let it thaw, then find out why. The usual reason is airflow, and that part is often yours to fix.
Check these first
Five-minute checks, no tools
Cooling off, fan on to thaw
Set the thermostat's system switch to Off and the fan to On. The fan blows room air over the ice and speeds the thaw. Expect it to take a few hours. Do not run cooling again until the ice is all gone.
No heat guns, no chipping
Let the ice melt on its own. A hair dryer, heater or a tool against the coil can crack it or bend the thin fins.
Watch for water
All that ice becomes water at once. Put towels around the unit and keep an eye on the drain pan and drain line while it thaws.
Check the filter
Pull the filter and hold it up to a light. If you cannot see through it, replace it. A clogged filter is the most common reason a coil freezes.
Returns clear, registers open
Move furniture and boxes off the return grilles and open the supply registers in every room. Closing a lot of vents starves the coil of air.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Clogged air filter
A filter packed with dust cuts the air over the coil until it freezes. It is the cheapest fix and the most common cause. Replace it before you run cooling again.
Fix the air filter5–15 min$5–$25 - 2DIY fix
Blocked returns or closed vents
Furniture over a return grille, or a lot of closed supply registers, cuts the airflow the same way a dirty filter does. Clear them and open the vents.
- 3DIY fix
Weak run capacitor (slow blower)
The blower runs slowly, starts late or only hums, while the outdoor unit keeps cooling the coil. A weak capacitor is a common reason a blower motor will not start or keep its speed.
Fix the capacitor20–45 min$10–$50 - 4DIY fix
Blower motor
The blower stops or never runs while the outdoor unit is cooling. With no air over it, the coil freezes fast. If the capacitor tests good, the motor is next.
Fix the blower motor1 hr–2.5 hr$150–$450 - 5Call a pro
Low refrigerant from a leak
The filter is clean, air flows freely, and the coil still freezes again after it thaws. Low refrigerant usually means a leak. Only a certified tech may find it, fix it and recharge the system.
- 6Call a pro
Dirty evaporator coil
Dust and grime on the coil itself block air like a second filter. It often follows years of dirty filters. Cleaning the coil inside the cabinet is a job for a pro.
What's happening
What your air handler is doing
In cooling mode, refrigerant runs through the indoor coil and makes it cold. The blower pushes warm house air across it. That steady stream of warm air keeps the coil from getting too cold while it pulls heat and moisture out of the air.
When too little air crosses the coil, it gets colder and colder until the moisture on it freezes. Ice blocks even more air, so it spreads. A clogged filter, blocked return grilles, closed vents, a dirty coil or a blower that is not running all do this.
Low refrigerant does it too. With less refrigerant, the pressure in the coil drops and so does its temperature, below freezing. That is a leak somewhere in the sealed system, and only a certified tech can find it and recharge it.
Running the system with a frozen coil can damage the outdoor compressor. So the first step is always the same: stop cooling and let the ice melt.
Know your limits
When to call a pro
Stop and call a pro if
- It freezes again after you have changed the filter and cleared the vents and returns.
- You suspect low refrigerant or a leak. Finding a leak and recharging the system needs a certified tech.
- The coil itself is caked with dirt and needs cleaning.
- Water is overflowing the pan or leaking through a ceiling while it thaws.
FAQ
Common questions
How long does a frozen AC coil take to thaw?
Usually a few hours, and longer if the ice is thick. Run the fan with the cooling off to speed it up. Do not restart cooling while there is still ice on the coil.
Will a frozen coil fix itself?
No. It will melt if you turn the cooling off, but whatever froze it is still there. Running the system frozen can damage the compressor. Find and fix the cause before you cool again.
Can I add refrigerant myself?
No. Under federal rules, only an EPA certified technician may add or remove refrigerant. Low refrigerant also means there is a leak, and topping it off without finding the leak only brings the ice back.
Why are the copper lines at the outdoor unit frosted?
Frost on the copper refrigerant lines at the outdoor unit is a common sign that the indoor coil is freezing. Thaw the system and work through the same checks: filter, returns and vents, then the blower.
Related
Keep going
- SymptomAir handler not blowing air: no airflow from the ventsThe blower inside the air handler is not moving air. A humming motor that never spins points to the run capacitor. Silence points to power, the blower door switch, a tripped float switch, the board or the motor. Ice on the coil can also block the air.Open guide
- SymptomWater in the air handler drain pan: pan full or system shut offWater is backing up in the drain pan under the coil, or in the pan under the unit, and the system may have shut itself off. A clogged condensate drain is the usual cause. A stuck float switch, a coil that froze and melted, or a cracked pan are the others.Open guide
- Air handler partAir filterFor heat pump and central air handlers, including units with electric heat strips. The filter cleans the air before it reaches the blower and coil. A clogged one chokes airflow, which can freeze the coil in summer and trip the heat strips in winter. Check it monthly.Open guide
- Air handler partBlower motor run capacitorFor heat pump and central air handlers with a PSC blower motor, including units with electric heat strips. The run capacitor helps the blower motor start and run. A weak one leaves the blower humming, slow or dead. Air handlers with an ECM motor have no capacitor.Open guide
- Air handler partBlower motor and wheelFor heat pump and central air handlers, including units with electric heat strips. The blower motor spins a squirrel-cage wheel that pulls air through the filter and coil and pushes it into the ducts. A dirty wheel chokes airflow, and a worn motor hums, squeals or stops.Open guide
- Air handler partEvaporator coilThe evaporator coil is the A-shaped coil of refrigerant tubing and thin fins inside the air handler. House air passes through it to be cooled. A dirty coil chokes the airflow, ice blocks it, and a leak leaves the system low on refrigerant. Coil service is pro work.Open guide
- Air handler partRefrigerant linesThe refrigerant lines, or line set, are the two copper tubes between the air handler's coil and the outdoor unit. A leak at a joint or in a line leaves the system low on refrigerant. Damaged insulation makes the lines sweat. Repairs need an EPA-certified technician.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy