Water standing in your air handler's drain pan
A pan full of water usually means one thing: the drain line is clogged. Good news: clearing it is a common homeowner fix, and the system often starts right back up.
Check these first
Five-minute checks, no tools
System off first
Set the thermostat to Off. Before you open any panel or reach into a pan with water in it, switch off the air handler's breakers and the disconnect at the unit.
Find the float switch
Look for a small switch on the drain line near the unit or clipped to the pan. If the float is up and the pan is full, it has done its job. Never bypass it to get the system running.
Check the drain outlet
Follow the drain line to where it ends, outside or at a floor drain. If nothing drips out while the system cools, or the end is blocked, the line is clogged.
Look at the pan under the unit
Water in the secondary pan under the air handler means the main pan inside has already overflowed. Dry it out and clear the drain before you run cooling again.
Check for ice
A coil that froze and is now melting can flood the pan in a short time. If you see frost on the coil or the copper lines, see [frozen coil](/air-handler/symptoms/frozen-coil).
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Clogged condensate drain
The pan is full and little or nothing comes out the end of the drain line. Algae and debris have plugged it. Clearing it with a wet-dry vac from the outside end, with the power off, often fixes it.
Fix the condensate drain20–45 min$0–$10 - 2DIY fix
Stuck or failed float switch
The drain runs freely but the system stays off, or the pan overflows without the system shutting down. The float may be stuck, set too low, or the switch has failed.
Fix the float switch20–45 min$15–$50 - 3DIY fix
Ice melting off a frozen coil
The coil froze, often from a clogged filter, and now all that ice is melting at once. The pan and drain cannot keep up. Replace the filter and see frozen coil for why it froze.
Fix the air filter5–15 min$5–$25 - 4Call a pro
Unit not level
If the air handler tilts away from the drain, water pools at the low end of the pan and can trip the float even with a clear drain line. The drain line also needs a steady downward slope.
- 5Call a pro
Cracked or rusted drain pan
Water drips from the unit even when the drain is clear, or the pan shows rust holes or cracks. The pan sits under the coil, so replacing it is a job for a pro.
What's happening
What your air handler is doing
When the air handler cools, the cold coil pulls moisture out of the air, the same way a cold glass sweats. That water drips into a drain pan right under the coil and runs out a drain line to a drain or outside.
Over time, algae, slime and dust grow in the line and narrow it. Water drains slower and slower, then backs up into the pan.
A float switch on the pan or drain line rises with the water. When the level gets too high, it shuts the system down, outdoor unit and blower included, before the pan overflows. So a full pan and a dead system often show up together.
Many air handlers, especially in attics, sit in a second, larger pan. Water in that secondary pan means the primary pan inside the unit has already overflowed.
Know your limits
When to call a pro
Stop and call a pro if
- Water has reached wiring, the heat strips or the control board. Leave every breaker off.
- The float switch keeps tripping after you have cleared the line, or you find no clog at all.
- The drain pan under the coil is cracked or rusted through.
- Water is coming through a ceiling below an attic air handler.
FAQ
Common questions
Why did my air conditioner shut off with water in the pan?
That is the float switch doing its job. When water backs up, it shuts the system down so the pan does not overflow. Clear the condensate drain and the switch should let the system start again.
How do I keep the drain line from clogging?
Flush it now and then with warm, not boiling, water or a cup of distilled white vinegar, and have it checked at each maintenance visit. Skip bleach, chlorine tablets and harsh drain chemicals, which can attack the coil or the plastic pipe and its joints. The condensate drain guide shows how, and your air handler's manual comes first if it says otherwise.
Is it normal to have a little water in the pan?
While the system cools, the pan catches water and drains it away, so it may be wet. Standing water that does not drain is not normal. It means the line is slow or clogged.
Can I just bypass the float switch?
No. It is the only thing between a clogged drain and a soaked ceiling or floor. With the switch bypassed and the line clogged, the pan can overflow within hours.
Related
Keep going
- SymptomAir handler coil frozen: ice on the evaporator coil or linesThe indoor coil has iced over, so little or no cool air reaches the vents. Turn the system off or to fan only and let it thaw. Then check the filter, the return grilles and the blower. If it keeps freezing, low refrigerant is a job for a certified pro.Open guide
- SymptomAir handler not blowing air: no airflow from the ventsThe blower inside the air handler is not moving air. A humming motor that never spins points to the run capacitor. Silence points to power, the blower door switch, a tripped float switch, the board or the motor. Ice on the coil can also block the air.Open guide
- Air handler partCondensate drain pan and lineFor heat pump and central air handlers, including units with electric heat strips. In cooling, the coil wrings water out of the air into a drain pan, and a pipe with a trap carries it away. When slime or debris blocks that pipe, the pan fills and a float switch shuts the system off.Open guide
- Air handler partFloat switchFor heat pump and central air handlers, including units with electric heat strips. The float switch sits on the drain pan or the drain line. When water rises, the float lifts and cuts the low-voltage control circuit so the system shuts off before the pan overflows.Open guide
- Air handler partAir filterFor heat pump and central air handlers, including units with electric heat strips. The filter cleans the air before it reaches the blower and coil. A clogged one chokes airflow, which can freeze the coil in summer and trip the heat strips in winter. Check it monthly.Open guide
- Air handler partEvaporator coilThe evaporator coil is the A-shaped coil of refrigerant tubing and thin fins inside the air handler. House air passes through it to be cooled. A dirty coil chokes the airflow, ice blocks it, and a leak leaves the system low on refrigerant. Coil service is pro work.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy