Garbage disposal won't turn on, no sound
Dead silence often means the overload tripped or the power is off somewhere. Check the red button first.
Check these first
Five-minute checks, no tools
Press the reset button
Turn off the wall switch and unplug the disposal, then gently press the red button on the bottom until it clicks and stays in. Some newer models have no button.
Breaker and GFCI
Check the breaker, and press reset on any GFCI outlet nearby. The disposal may share a circuit with the dishwasher or other kitchen outlets.
Plug pushed in
Under the sink, check the plug is fully in the outlet. Things stored there can knock it loose.
Test the outlet
Unplug the disposal, plug a lamp into its outlet and flip the wall switch. If the lamp does not light, the problem is the power, not the disposal.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Tripped overload
The red reset button has popped out after a jam or overheat.
Fix the reset2–15 min$0 - 2DIY fix
Tripped breaker or GFCI
No power at the outlet. A lamp will not light either.
- 3DIY fix
Plug, cord or connection
A loose plug, a damaged cord, or a loose wire in the box on the bottom.
Fix the power cord15–30 min$10–$30 - 4Call a pro
Wall switch
The outlet has power only when the switch is on. A worn switch can stop it.
- 5DIY fix
Dead motor
Power reaches it, the reset is in, and it is still silent.
Fix the replace the unit1 hr–3 hr$100–$300
What's happening
What your garbage disposal is doing
No sound at all means no power is reaching the motor. Most often the thermal overload has tripped after a jam or a long grind, and the red reset button has popped out.
If the reset is in, the power is likely stopping earlier: the breaker, a GFCI outlet, the plug, the cord or the wall switch.
Know your limits
When to call a pro
Stop and call a pro if
- The breaker trips again as soon as you reset it. Free any jam first. If it still trips, call an electrician.
- The wall switch or outlet is warm, scorched or crackles. Call an electrician.
- Power reaches the disposal, the reset is in, and it is still dead. It is time for a new unit.
FAQ
Common questions
Where is the reset button?
On the bottom of the unit on most models, sometimes low on the side. It is usually red. See how to reset a disposal.
The reset will not stay in. Why?
The motor is still too hot. Wait about ten minutes and try again.
Is it the switch or the disposal?
Unplug the disposal, plug a lamp into the outlet and flip the switch. If the lamp lights, the switch and outlet are fine and the problem is the disposal or its cord.
Related
Keep going
- SymptomGarbage disposal hums but won't spinYou flip the switch and hear a hum, but no grinding. Usually the flywheel is jammed. Power off, turn it with a hex key from below, remove the object, and reset.Open guide
- Garbage disposal partReset buttonThe reset button is a thermal overload. It pops out to cut power when the motor overheats or jams. Free any jam, let it cool, and press it back in.Open guide
- Garbage disposal partPower cordA plug-in disposal gets power through a cord wired into a small box on its bottom. A damaged cord, or a new disposal without one, needs a cord kit. Breaker off, three wires, cover on.Open guide
- Garbage disposal partWhole disposal unitWhen the body cracks, it leaks from the bottom or the reset button, or the motor is dead, the disposal gets replaced as a unit. Unhook it, move the cord, hang the new one and reconnect the drains.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
