WhatsBusted
3D model of a garbage disposal
Symptom

Garbage disposal hums but won't spin

Switch it off now. A hum with no spin means the motor has power but cannot turn, and a hex key under the sink usually frees it in a minute.

Check these first

Five-minute checks, no tools

  • Switch it off now

    Turn off the wall switch right away, then unplug it or switch off its breaker.

  • Turn it with a hex key

    With the power off, put the jam wrench or a 1/4 in. hex key in the socket at the center of the bottom and crank it both ways until it turns freely.

  • Press reset

    Let it cool a few minutes, then gently press the red button on the bottom until it stays in.

Likely causes

Ranked by how often they are the problem

  1. 1

    Jammed flywheel

    DIY fix

    A bone, pit, utensil or bottle cap wedged in the chamber. The usual cause.

    Fix the unjam it5–15 min$0–$10
  2. 2

    Overload about to trip

    DIY fix

    A hum that stops and goes silent means the overload has tripped from the strain. Free the jam, then reset.

    Fix the reset2–15 min$0
  3. 3

    Seized motor or worn unit

    DIY fix

    The flywheel will not move even with the hex key, or it turns freely and the motor still only hums.

    Fix the replace the unit1 hr–3 hr$100–$300

What's happening

What your garbage disposal is doing

The motor is getting power and trying to turn, but something is wedged between the flywheel and the grind ring.

If you leave it humming, the motor heats up and the overload trips. Then it goes silent, and on most models the red reset button pops out.

Know your limits

When to call a pro

Stop and call a pro if

  • You smell burning, see smoke or notice a leak.
  • The flywheel will not move at all with the hex key.

FAQ

Common questions

Is it safe to keep switching it on to clear the jam?

No. Each hum heats the motor. Power it off and use the hex key instead. See how to unjam a disposal.

Can I use my hand to clear it?

Never. Use tongs or pliers, with the power off and unplugged.

It hummed, then went silent. Is it broken?

Probably not. The overload tripped. Free the jam, then press the reset button.

Related

Keep going

Get the next fix before it breaks

A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.

We send it with Kit. Privacy