How to unjam a garbage disposal
Good news: a humming disposal that will not spin is usually just jammed. A hex key under the sink often fixes it in a few minutes.
- Difficulty
- Anyone can do it
- Time
- 5–15 min
- Typical part cost
- $0–$10Pro: $75–$175
- Tools
- 3See the list
A hex key, a flashlight and tongs. No disassembly.
What it does
What the unjam it does
Inside the disposal, a flat plate called the flywheel spins with metal lugs on top. They throw food against the toothed grind ring around the chamber.
Most disposals have a hex socket in the center of the bottom that turns that plate by hand, so you can free a jam without reaching inside.
Why it fails
Bones, fruit pits, cutlery, bottle caps or a wad of fibrous peels wedge between a lug and the ring. The motor hums but cannot turn.
If it hums for long, the motor overheats and the thermal overload trips. Then it goes silent until you reset it.
Symptoms
Signs of a bad unjam it
Hums but will not spin
You hear a steady hum when you flip the switch, but no grinding. Switch it off right away.
Full diagnosisStopped mid-grind
It was grinding something hard or fibrous, then stopped or slowed to a hum.
Full diagnosisSilent after humming
It hummed, then went quiet. The overload tripped. Free the jam, then press the reset button.
Full diagnosis
How to test it
Test the unjam it before you buy
- Switch off and unplug the disposal, or switch off its breaker.
- Put the hex key in the socket in the center of the bottom of the unit and try to turn it both ways.
- Good
- It turns a full circle both ways. The jam is free. Remove the object and reset.
- Bad
- It will not move at all, even after working it back and forth. Something hard is wedged or the motor is seized.
Safety first
Before you touch anything
- 1
Switch off and unplug
Turn the wall switch off, then unplug the disposal under the sink, or switch off its breaker if it is hardwired.
- 2
Never put your hand inside
Even with the power off, use tongs or pliers to take anything out of the chamber.
Tools you'll need
Grab these first
Tool and part links are affiliate links. We may earn a commission at no extra cost to you, and it never changes what we tell you to check first. How this works
- Hex key1/4 in.Fits the socket in the bottom of most disposals and turns the flywheel by hand.Typically $5–$10Shop this tool
- HeadlampTo see into the chamber and under the sink.Typically $12–$30Shop this tool
- Needle-nose pliersPulls the freed object out of the chamber. Tongs work too.Typically $8–$20Shop this tool
Step by step
How to replace the unjam it
- 1
Switch off and unplug
Turn off the wall switch. Unplug the disposal under the sink, or switch off its breaker.
- 2
Work the flywheel free
Find the hex socket in the center of the bottom of the unit. Push the hex key in and work it back and forth like a crank.
Keep going until it turns full circles in both directions.
Tip. No hex key? Many units take a standard 1/4 in. hex key. Some models have no socket: with the power off, a wooden spoon or broom handle pushed against a lug from above can rock the plate.
- 3
Take out what jammed it
Shine a light down the drain. Lift out whatever is loose with tongs or needle-nose pliers.
Careful. Do not reach in with your fingers, even now.
- 4
Press the reset button
Let the motor cool for a few minutes. Then gently press the red button on the bottom of the unit until it clicks and stays in. Some newer models reset on their own and have no button.
Buy the part
Jammed flywheel
Opens Amazon in a new tab. Where’s my model number?
What to look for
- A 1/4 in. hex key fits many disposals. Check your manual for the right size.
Many disposals come with a small wrench for this. A standard 1/4 in. hex key works the same.
- 5
Power on and test
Plug it back in or switch the breaker on. Turn on cold water first, then switch it on. It should spin up quickly. If it jams again, switch off and repeat.
Buy the part
Get the right replacement
Buy the part
Jammed flywheel
Opens Amazon in a new tab. Where’s my model number?
What to look for
- A 1/4 in. hex key fits many disposals. Check your manual for the right size.
Many disposals come with a small wrench for this. A standard 1/4 in. hex key works the same.
Know your limits
When to call a pro
Stop and call a pro if
- You smell burning, see smoke or notice a leak. Stop and call a pro.
- The flywheel will not move at all with the hex key.
- It jams again and again with normal use, or it still hums once the plate turns freely. The unit may be worn out.
FAQ
Jammed flywheel questions
My disposal has no hex socket on the bottom. Now what?
With the power off, push a wooden spoon or broom handle down against one of the lugs and rock the plate back and forth. Then remove the object with tongs.
Why does it just hum?
Humming without spinning almost always means the flywheel is jammed. Switch it off right away so the motor does not overheat.
What should not go in a disposal?
Never grease, fat, oil or anything that is not food. Most units also struggle with hard items like bones and pits, stringy foods like celery, and big loads of peels or starchy food. What yours can take depends on the model, so check the manual. Run cold water while it grinds.
Related
Keep going
- SymptomGarbage disposal hums but won't spinYou flip the switch and hear a hum, but no grinding. Usually the flywheel is jammed. Power off, turn it with a hex key from below, remove the object, and reset.Open guide
- SymptomGarbage disposal won't turn onYou flip the switch and hear nothing at all. A tripped reset button is the first thing to check. A tripped breaker or GFCI, a loose plug, a bad cord or switch, or a dead motor come next.Open guide
- SymptomGarbage disposal making loud noisesRattles, clanks or harsh grinding from the disposal. A spoon, a bottle cap or a knockout plug in the chamber is the usual cause. Loose mounting or worn parts come next.Open guide
- Garbage disposal partReset buttonThe reset button is a thermal overload. It pops out to cut power when the motor overheats or jams. Free any jam, let it cool, and press it back in.Open guide
- Garbage disposal partWhole disposal unitWhen the body cracks, it leaks from the bottom or the reset button, or the motor is dead, the disposal gets replaced as a unit. Unhook it, move the cord, hang the new one and reconnect the drains.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
