How to clean refrigerator condenser coils
A refrigerator that runs warm or never seems to shut off sometimes just needs a vacuum. It is the cheapest fix on this list.
- Difficulty
- Anyone can do it
- Time
- 15–30 min
- Typical part cost
- $0–$15Pro: $70–$130
- Tools
- 2See the list
A vacuum, a soft brush and maybe a nut driver. The only care point is not bending the thin fins or tubing.
What it does
What the condenser coils does
Refrigerant carries heat from inside the refrigerator to the condenser coil. On most models the coil is under the cabinet, behind the base grille or the rear access panel, and a fan pulls room air through it. Some older models have the coil on the back.
Anything that blocks that airflow, a dusty coil, a blocked grille or a refrigerator pushed too tight to the wall, makes the whole system work harder.
Why it fails
The coil does not wear out, it clogs with dust and lint.
Cleaning cannot fix a refrigerant leak or a failed compressor. If the coils are clean and the refrigerator still runs warm, keep troubleshooting.
Symptoms
Signs of a bad condenser coils
Warm and running a lot
Both sections run a little warm and the compressor rarely seems to stop.
Full diagnosisGrey fuzz on the grille
Dust packed into the base grille or visible on the coil behind it.
Hot air at the bottom
The air blowing out from under the refrigerator feels hotter than usual.
How to test it
Test the condenser coils before you buy
- Unplug the refrigerator and snap off the base grille at the bottom front, or pull it out and remove the rear access panel. Your manual says which.
- Shine a light on the coil.
- Good
- You can see bare metal tubes and fins. The coil is not your problem. Put the grille back.
- Bad
- Dust, lint or hair coats the coil. Clean it (steps below).
Safety first
Before you touch anything
- 1
Unplug the refrigerator
Unplug it, or switch off its breaker, before you reach in. The condenser fan can start without warning.
- 2
Gentle on the fins
The tubing carries refrigerant. Brush along the fins, not across them, and do not poke or pry. A damaged tube is a sealed-system repair.
Tools you'll need
Grab these first
Tool and part links are affiliate links. We may earn a commission at no extra cost to you, and it never changes what we tell you to check first. How this works
- Shop vacuumA vacuum with a crevice tool and brush pulls the dust out of the coil.Typically $40–$90Shop this tool
- Stiff nylon brushA soft brush loosens dust from between the fins without bending them.Typically $5–$12Shop this tool
- Nut driver1/4 in. hexOptionalRemoves the rear access panel if your coil is behind it.Typically $6–$15Shop this tool
- Dust maskN95OptionalCoil dust is fine and gets everywhere.Typically $10–$25Shop this tool
Step by step
How to clean the condenser coils
- 1
Unplug it
Unplug the refrigerator. If you need to pull it out and it has a water line, close the supply valve and pull it out slowly so the line does not kink.
- 2
Get to the coil
Most coils are reached through the base grille at the bottom front: pull it straight off. On models with a machine compartment at the back, pull the refrigerator out and remove the lower rear panel.
Some models are designed so the coil needs no routine cleaning, or can only be reached by a technician. Your owner's manual will say.
- 3
Brush and vacuum
Vacuum the grille, the open areas behind it and the front of the coil with a soft brush attachment.
Work a soft brush gently along the fins to loosen packed dust, and vacuum it up as it falls. Clean around the condenser fan blade too.
- 4
Put it back and power up
Refit the base grille or the rear panel, plug the refrigerator in and push it back, leaving the space at the back and top your manual asks for. Do not block the base grille.
Buy the part
Get the right replacement
Buy the part
Condenser coils
Opens Amazon in a new tab. Where’s my model number?
What to look for
- A long, thin, flexible brush made for refrigerator coils reaches under the cabinet.
- Nothing stiff or metal that could bend the fins.
Know your limits
When to call a pro
Stop and call a pro if
- The coil is clean and the refrigerator still runs warm with both fans working.
- You see oily residue on the coil or tubing, or a tube is bent or kinked.
- Your manual says the coil is technician-access only.
FAQ
Condenser coils questions
How often should I clean the coils?
It depends on your home and your model. Some manufacturers say their coils need no routine cleaning in a normal home; others say to clean them regularly. Check the coil once or twice a year and clean it when you see dust.
Can I use a hose or a coil cleaner spray?
Not on a refrigerator. The coil sits right next to the compressor and the electrical parts. Dry cleaning with a brush and vacuum is the safe way.
Will cleaning the coils lower my power bill?
A clean coil lets the refrigerator shed heat more easily, so it does not have to run as long to stay cold.
Related
Keep going
- SymptomRefrigerator not coolingThe freezer and the fresh-food section are both too warm. The usual causes are a dirty condenser coil, a stopped condenser fan, a failed start relay or an iced-over evaporator coil. The sealed system is the last thing to suspect, not the first.Open guide
- SymptomRefrigerator making noiseClicks, pops, gurgles, hums and sizzles are usually normal. A squeal or chirp from the freezer points to the evaporator fan. A rattle or squeal from the bottom back points to the condenser fan. Repeated clicking with no cooling points to the start relay.Open guide
- Refrigerator partCondenser fan motorThe condenser fan sits in the machine compartment at the bottom back. It pulls air through the condenser coil and over the compressor. When it stops, heat cannot leave and the whole refrigerator warms up.Open guide
- Refrigerator partCompressor start relay and overloadThe start relay plugs onto the side of the compressor and helps it start. When it fails, the compressor never starts and you hear a click every few minutes as it tries. It pulls straight off and pushes straight on.Open guide
- Refrigerator partDoor gasketThe door gasket is the soft magnetic seal around each door. When it tears, hardens or pulls away, warm air leaks in: you get condensation, frost near the door and a refrigerator that runs and runs.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy