Refrigerator defrost heater test and replacement
A freezer coil packed in white ice usually means the defrost system quit. The heater is a common culprit, and you can test it in a minute.
- Difficulty
- Moderate
- Time
- 45 min–1.5 hr
- Typical part cost
- $20–$60Pro: $120–$400
- Tools
- 4See the list
The test is easy. The swap means emptying the freezer, melting any ice, and working around sharp fins and refrigerant tubing without bending either.
What it does
What the defrost heater does
Frost builds up on the evaporator coil every time the door opens and humid air gets in. After a set amount of compressor run time, the refrigerator stops cooling and sends power to the defrost heater, a glass tube or metal rod mounted under or through the coil.
The heater warms the coil until the frost melts. A defrost thermostat clipped to the coil cuts the heater off once the coil is clear, and the water runs down the drain to a pan under the cabinet.
If you hear sizzling or popping in the freezer for a while, that is usually melt water dripping onto the warm heater. It is normal.
Why it fails
The heater element simply burns open with age, like a light bulb filament. Once it is open, no current flows and the coil is never defrosted.
Glass-tube heaters can crack if they get bumped or if someone chips at the ice with a tool.
A heater that tests good may still not get power. The defrost thermostat, the defrost timer or the control board decides when it runs, so test those if the heater checks out.
Symptoms
Signs of a bad defrost heater
Coil packed with ice
Take off the freezer's rear panel. A coil covered in thick white frost or solid ice, instead of a light dusting, means defrost is not happening.
Full diagnosisFridge warms first
Frost blocks the air path, so the fresh-food section usually warms up while the freezer still feels cold.
Full diagnosisFrost on the back wall or vents
Frost or ice creeping out from behind the rear panel or around the vents is another sign the coil behind it is iced over.
Full diagnosisFan noise or a stopped fan
As ice grows it can reach the evaporator fan blade, which scrapes, then stalls.
Full diagnosis
How to test it
Test the defrost heater before you buy
- Unplug the refrigerator, empty the freezer and take off the rear panel.
- Look at the coil and the heater under it.
Let the ice melt with the refrigerator unplugged, the doors open and towels down. Never chip at it.
- Good
- A light, even layer of frost. Defrost is probably working. Look at the fans and the coils instead.
- Bad
- The coil is packed with ice, especially from the bottom up. Melt it off, then do the resistance test.
- With the refrigerator unplugged, find the heater's two wires and disconnect them, at the heater terminals or at its plug.
- Touch one probe to each heater wire or terminal.
- Wait for the reading to settle.
A good heater typically reads
About 10–150 Ω (some read about 30–42 Ω)
Typical range. Check your part label or manual for the exact spec. On some models a defrost fuse or the defrost thermostat is wired in series with the heater. Then an open reading can be either part, so test them separately.
- Good
- A steady reading in the range for your heater means it is intact. Test the defrost thermostat and the timer or control next.
- Bad
- OL (open) means the heater has burned out. Replace it.
Safety first
Before you touch anything
- 1
Unplug the refrigerator
Pull the plug at the wall, or switch off its breaker. The heater runs on household voltage during defrost.
- 2
Gloves, and no tools on the ice
The coil fins are sharp and the tubing is thin. Wear gloves. Melt ice with time or gentle warm air, never a knife or screwdriver. A punctured tube is a sealed-system repair.
- 3
Towels down
Melting ice makes a lot of water. Lay towels in the freezer and on the floor in front of it.
Tools you'll need
Grab these first
Tool and part links are affiliate links. We may earn a commission at no extra cost to you, and it never changes what we tell you to check first. How this works
- Nut driver1/4 in. hexThe freezer rear panel and heater clips are usually 1/4 in. hex screws.Typically $6–$15Shop this tool
- Multi-bit screwdriverPhillips, flat, squareFor Phillips or Torx panel screws on some models.Typically $10–$25Shop this tool
- Digital multimeterΩ, V, µF, µAA resistance reading tells you in seconds whether the heater is open.Typically $25–$60Shop this tool
- Work glovesProtects your hands from the sharp evaporator fins.Typically $8–$20Shop this tool
- Needle-nose pliersOptionalHelps release the small spring clips that hold some heaters.Typically $8–$20Shop this tool
Step by step
How to replace the defrost heater
- 1
Unplug it and empty the freezer
Unplug the refrigerator. Move frozen food into coolers. Take out the freezer shelves and baskets, and the ice bin if it is in the way.
- 2
Remove the rear panel
Take out the screws holding the freezer's rear panel. Tip it forward and lift it out, unplugging any light or sensor wire first.
- 3
Melt any ice
If the coil is iced over, let it melt completely before you touch the heater. With the doors open this can take a few hours.
Sponge up the water as it melts so it does not overflow the drain.
Careful. Do not chip or pry at the ice. The fins and tubes are easy to damage.
- 4
Disconnect the heater wires
Find where the heater's two wires connect: on terminals at the heater ends, or at a plug nearby. Take a photo, then disconnect them.
Do the resistance test now if you have not already.
- 5
Release the old heater
Heaters are held by clips, brackets or screws along the bottom of the coil. Release them and ease the heater out, keeping it clear of the fins and tubing.
On some models the defrost thermostat is part of the same assembly. Note where it was clipped so the new one goes back the same way.
- 6
Match the new heater
Hold the old and new heaters side by side. The length, shape, mounting and wire ends should match. Glass-tube and metal-rod heaters are not interchangeable unless the kit says so.
Buy the part
Defrost heater
Opens Amazon in a new tab. Where’s my model number?
What to look for
- The part number printed on the old heater or its tag, or the one in your model's parts list.
- The same type: glass tube, metal rod or flat foil, and the same length and wire ends.
- Whether the kit includes a new defrost thermostat. It is cheap insurance to replace both at once.
Defrost heaters are model specific. Buy the one matched to your model number.
- 7
Fit the new heater
Set the heater in the same position as the old one and refit every clip, bracket or screw. Reconnect the wires the way your photo shows.
If the defrost thermostat came off, clip it back to the same tube on the coil. It has to touch the coil to read it.
- 8
Close up and power on
Refit the rear panel, the shelves and the food. Plug the refrigerator in.
It can take up to 24 hours to settle back to temperature. Check the coil in a few days if you want to be sure the defrost is clearing it.
Buy the part
Get the right replacement
Buy the part
Defrost heater
Opens Amazon in a new tab. Where’s my model number?
What to look for
- The part number printed on the old heater or its tag, or the one in your model's parts list.
- The same type: glass tube, metal rod or flat foil, and the same length and wire ends.
- Whether the kit includes a new defrost thermostat. It is cheap insurance to replace both at once.
Defrost heaters are model specific. Buy the one matched to your model number.
Know your limits
When to call a pro
Stop and call a pro if
- The coil ices over again within a few weeks of a new heater and thermostat.
- You damaged a fin or a tube, or you see oily residue on the coil. That is a refrigerant leak and sealed-system work.
- The heater tests good but never gets power, and you are not comfortable testing the control board.
FAQ
Defrost heater questions
How often does a refrigerator defrost?
It varies by model. Timer-based models defrost after a set amount of compressor run time, then return to cooling after a short defrost period. Models without a timer decide on their own. Either way, it happens without you noticing most of the time.
Can I just defrost the freezer by hand instead?
Melting the ice will get the refrigerator cooling again for a while, which is a useful test. If the heater is bad, the ice comes back.
Should I replace the defrost thermostat at the same time?
It is a reasonable idea. The defrost thermostat is cheap, it is right there, and it is hard to test properly unless it is cold.
The sizzling noise in my freezer: is that the heater?
Usually, yes, and it is normal. Melt water dripping onto the warm heater sizzles or pops during the defrost cycle.
Related
Keep going
- SymptomRefrigerator freezer frosting upA frost-free freezer should never need defrosting by hand. Frost near the door usually means a leaking gasket. Thick ice behind the rear panel, on the coil, means the defrost heater, the defrost thermostat or the defrost timer has failed.Open guide
- SymptomFreezer cold but fridge warmThe freezer still freezes but the fresh-food section warms up. All the cold comes from one coil in the freezer, so this usually means air is not moving: a stopped evaporator fan, an iced-over coil, or a blocked vent.Open guide
- SymptomRefrigerator not coolingThe freezer and the fresh-food section are both too warm. The usual causes are a dirty condenser coil, a stopped condenser fan, a failed start relay or an iced-over evaporator coil. The sealed system is the last thing to suspect, not the first.Open guide
- Refrigerator partDefrost thermostatThe defrost thermostat is a small temperature switch on the evaporator coil. It lets the defrost heater run only while the coil is cold. If it sticks open, the heater never gets power and the coil ices over.Open guide
- Refrigerator partDefrost timerThe defrost timer switches the refrigerator between cooling and defrosting. If it stops advancing, the coil never defrosts and ices over, or the refrigerator gets stuck in defrost and stops cooling altogether.Open guide
- Refrigerator partEvaporator fan motorThe evaporator fan blows the freezer coil's cold air around the freezer and into the fresh-food section. When it stops, the freezer can stay cold while the fridge warms up. It is usually a few screws and one plug.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
