WhatsBusted
3D model of a defrost timer
Also called refrigerator defrost timer, defrost control timer

Refrigerator defrost timer test and replacement

On models that have one, the defrost timer is a small box with a slot you can turn with a screwdriver. That slot is also the best test.

Difficulty
Easy
Time
20–45 min
Typical part cost
$30–$150Pro: $130–$260

Finding it is the hard part. Once you have it, it is a screw or two and one plug.

What it does

What the defrost timer does

On models with a mechanical defrost timer, the timer's little motor runs only while the compressor runs. After a set amount of run time, a cam inside switches the power from the cooling side to the defrost heater. After a short defrost period it switches back.

It is usually behind the lower front kick plate, inside the control housing in the fresh-food section, or on the back of the cabinet. It has four terminals and a slot or knob on one face for turning it by hand.

Not every refrigerator has one. Many newer models handle defrost from the control board. If you cannot find a timer, check your wiring diagram before you buy one.

Why it fails

The timer motor can stop turning, so the switch never moves. If it stops in the cooling position the coil ices over. If it stops in defrost, the compressor and fans never come back on.

The contacts inside wear with age and can stick or burn.

Symptoms

Signs of a bad defrost timer

  • Coil iced over, heater and thermostat good

    Thick frost on the evaporator coil, but the defrost heater and the defrost thermostat both test fine. The timer may not be starting defrost.

    Full diagnosis
  • Lights on, nothing running

    The light works, but the compressor and fans stay off for well over half an hour. The timer may be stuck in defrost.

    Full diagnosis
  • Runs and runs

    The refrigerator runs nonstop and slowly ices up, because it never gets a defrost break.

    Full diagnosis

How to test it

Test the defrost timer before you buy

1. Advance it by handNo meter needed
  1. With the refrigerator running, find the timer and put an insulated flat screwdriver in its slot. Touch nothing else.
  2. Turn it slowly clockwise until you hear a click. The compressor and fans should stop and, after a few minutes, you may hear sizzling in the freezer as the heater warms the coil.
  3. Keep turning until it clicks again. The compressor and fans should come back on.

Turn it only clockwise and gently. Forcing it can strip the gears.

Good
It switches into defrost and back out cleanly. The timer's switch works. Watch over a day or two whether it advances on its own; mark the slot's position with a pencil to check.
Bad
Nothing changes when it clicks, or it never moves on its own over a day or two of running. Replace the timer.
2. Timer motor checkMeter on Ω (resistance)
  1. Unplug the refrigerator and pull the timer's plug.
  2. Find the terminal numbers stamped beside each terminal. On a common layout, 1 is common, 2 goes to the defrost heater, 3 to the timer motor and 4 to the compressor. Check your timer's own markings.
  3. Probe the two terminals for the timer motor. Check the wiring diagram on the timer or the refrigerator to find them.

A good timer motor typically shows

Continuity: a steady reading, not OL

Typical range. Check your part label or manual for the exact spec. There should never be continuity between the defrost and compressor terminals (2 and 4 on a common layout) at the same time.

Good
A reading means the motor winding is intact.
Bad
OL means the motor is open and the timer cannot advance. Replace it.

Safety first

Before you touch anything

  1. 1

    Unplug before you remove it

    The hand-advance test is done running, with your screwdriver only in the plastic slot. Unplug the refrigerator before you touch any terminal or remove the timer.

Tools you'll need

Grab these first

Tool and part links are affiliate links. We may earn a commission at no extra cost to you, and it never changes what we tell you to check first. How this works

See the full repair tool kit

Step by step

How to replace the defrost timer

  1. 1

    Unplug the refrigerator

    Pull the plug at the wall, or switch off its breaker.

  2. 2

    Find the timer

    Check behind the kick plate at the bottom front first. If it is not there, look in the control housing at the top of the fresh-food section, then on the back of the cabinet near the bottom.

    Remove the cover or kick plate that hides it.

  3. 3

    Remove it and unplug it

    Take out the screw or screws holding the timer and pull it forward.

    Photograph the wires, then pull the plug or the individual wires off. Pull on the connectors, not the wires.

  4. 4

    Match the new timer

    Compare the terminal numbers, the plug and the mounting. If the new timer has a separate loose lead, its instructions will say which terminal it goes on. Getting that wrong stops it from advancing.

  5. Buy the part

    Defrost timer

    Opens Amazon in a new tab. Where’s my model number?

    What to look for

    • The part number on the timer's label, or the one in your model's parts list.
    • The same terminal layout and plug. Run times and defrost lengths differ between timers, so match your model.

    Universal electronic defrost timers exist and fit many timer-defrost refrigerators. Follow the kit's wiring instructions exactly.

  6. 5

    Install and power up

    Connect the plug or wires to match your photo, mount the timer and refit the cover.

    Plug the refrigerator in. If nothing starts, the new timer may be in defrost. Turn it clockwise until it clicks out of defrost.

Buy the part

Get the right replacement

Buy the part

Defrost timer

Opens Amazon in a new tab. Where’s my model number?

What to look for

  • The part number on the timer's label, or the one in your model's parts list.
  • The same terminal layout and plug. Run times and defrost lengths differ between timers, so match your model.

Universal electronic defrost timers exist and fit many timer-defrost refrigerators. Follow the kit's wiring instructions exactly.

Know your limits

When to call a pro

Stop and call a pro if

  • Your refrigerator has no defrost timer and defrost is handled by the control board.
  • A new timer advances but the coil still ices over, and the heater and thermostat test good.
  • The compressor does not start when the timer clicks out of defrost.

FAQ

Defrost timer questions

My refrigerator stopped for half an hour. Is the timer stuck?

Not necessarily. During defrost the refrigerator stops cooling, and manufacturers say to wait about 30 minutes for it to finish. If it stays off much longer than that, try advancing the timer.

Can I leave it in defrost to melt a frozen coil?

It is not a good way to clear heavy ice. Unplug the refrigerator and let it thaw with the doors open instead.

How do I know if my refrigerator has a defrost timer?

Look behind the kick plate and in the fresh-food control housing for a small box with four terminals and a slot on its face. Your model's parts list or the wiring diagram on the back of the cabinet will also show it.

Related

Keep going

Get the next fix before it breaks

A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.

We send it with Kit. Privacy