Freezer drawer won't close
Most of the time it is the load, not a part: a basket off its track, a box riding too high, or a ridge of ice at the back. Empty it out and look before you order anything.
Check these first
Five-minute checks, no tools
Nothing above the fill line
Pull the drawer out and look for a box or bag sticking up past the top of the basket, or something fallen behind it.
Basket on its rails
Lift the basket out and set it back so it sits flat on both rails. Some baskets only fit one way round and are marked for the front.
No ice on the rails or back wall
Look along the rails, the gasket and the back of the freezer for a ridge of frost or ice. Unplug the refrigerator and melt it with warm water, never a metal tool.
Drawer reseated
Pull the drawer partway open and close it firmly without slamming. On drawers with a roller bar linking the two slides, check the bar is in place and rolling, and reseat it as your manual shows.
Refrigerator level
Check the cabinet with a level. It should be level side to side, with the front slightly higher than the back.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Basket off its rails or overfilled
The drawer stops short or bounces back. Take some things out, set the basket flat on its rails and see if the drawer then closes flush.
- 2DIY fix
Ice on the rails or behind the drawer
A ridge of frost or ice the drawer runs into. Unplug, melt it with warm water and dry everything. If it comes back, the drawer is not sealing, or a sheet of ice on the floor points to a blocked defrost drain: see frost buildup.
- 3DIY fix
Bent slide or broken roller
One side of the drawer leads the other as it slides, or a roller is cracked or flat-spotted. Replace the slides as a pair so the drawer closes square.
Fix the drawer slides30 min–1 hr$15–$270 - 4DIY fix
Torn or folded drawer gasket
The drawer looks closed but frost keeps forming. A torn, hard or folded-over gasket cannot seal. A sheet of paper closed in the drawer should drag when you pull it.
Fix the door gasket30 min–1 hr$50–$130 - 5DIY fix
Refrigerator out of level
The drawer sits crooked and the doors above may be uneven too. Level the cabinet side to side with the front a little higher than the back.
Fix the door alignment20 min–1 hr$0
What's happening
What your refrigerator is doing
The freezer drawer rides on a pair of slides, one on each side, with a basket sitting on top of them. To seal, the drawer front has to come in square and press its gasket flat against the cabinet all the way round.
Anything that stops it a fraction short breaks the seal: a package standing above the fill line, a basket that has jumped its rails, or a ridge of ice on the rails or at the back of the freezer.
A drawer that does not seal lets damp air in, and that air turns into more frost and ice. So a drawer that starts closing badly tends to get worse until you clear the ice and fix the cause.
Know your limits
When to call a pro
Stop and call a pro if
- Ice keeps building up at the back of the freezer even with the drawer sealing well.
- The freezer will not stay near 0°F once the drawer closes properly.
- A slide or roller mount has broken off the cabinet liner itself.
FAQ
Common questions
Can I chip the ice off the freezer rails?
No. A metal tool can puncture the liner or the tubing behind it. Unplug the refrigerator and melt the ice with warm water, then dry the rails and gasket before you plug it back in.
Should I replace one drawer slide or both?
Both. A new slide on one side and a worn one on the other makes the drawer close crooked, and a crooked drawer never seals square. Order them by your model number.
Why does my freezer drawer keep icing up?
Because it is not sealing. Damp kitchen air gets in past a drawer that stops short or a gasket that is torn, and freezes on the rails and back wall. Fix the seal and the ice stops coming back.
Related
Keep going
- SymptomRefrigerator freezer frosting upA frost-free freezer should never need defrosting by hand. Frost near the door usually means a leaking gasket. Thick ice behind the rear panel, on the coil, means the defrost heater, the defrost thermostat or the defrost timer has failed.Open guide
- SymptomFrench doors uneven or will not sealFrench-door refrigerators only. One door sits higher than the other, the doors will not swing shut on their own, or there is a gap where they meet. Level the cabinet with a slight tilt back, clear anything in the way, flip the center seal back into place, then adjust the door height.Open guide
- Refrigerator partFreezer drawer slidesFrench-door refrigerators only. The freezer drawer rides out on two slides with rollers. A drawer that will not close or sits crooked usually has a basket off its rails, too much food, frost in the track, or a broken roller or bent slide. A sheet of ice behind the drawer is a defrost problem, not a slide problem.Open guide
- Refrigerator partDoor gasketThe door gasket is the soft magnetic seal around each door. When it tears, hardens or pulls away, warm air leaks in: you get condensation, frost near the door and a refrigerator that runs and runs.Open guide
- Refrigerator partFrench-door alignmentFrench-door refrigerators only. Uneven doors are usually a cabinet that is not level or tilted forward. Level it with the front legs first, then fine-tune the door height at the bottom hinge as your manual describes, and check the center flap and the gaskets.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy