Dryer takes too long to dry clothes
The dryer heats and tumbles, it just cannot get the water out fast enough. Most of the time the fix is about airflow, and airflow is cheap to fix.
Check these first
Five-minute checks, no tools
Lint screen clean and open
Clear the [lint screen](/dryer/lint-screen), then run water over it. If water pools, softener film is blocking it. Wash it.
Strong air at the outside hood
With the dryer running, go outside. The flap should open and the air should feel strong and warm. Weak air means a restriction.
Duct not crushed behind the dryer
Unplug the dryer and look behind it. The duct should be round, with no kinks or flat spots.
Load not too big or too wet
Clothes need room to tumble. Split big or mixed loads, and make sure the washer's spin finished so clothes are not dripping.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Clogged or crushed vent duct
Lint packed in the duct, a crushed duct behind the dryer, a long run with many bends, or a stuck outside flap. Weak air outside is the giveaway.
Fix the exhaust vent30 min–1.5 hr$15–$30 - 2DIY fix
Load too big or too wet
An overloaded drum cannot tumble the clothes, and clothes that come out of the washer very wet carry extra water. Smaller loads dry faster.
- 3DIY fix
Lint screen clogged
A full screen, or one coated in softener film, chokes the airflow. Clear it every load and wash it now and then.
Fix the lint screen5–20 min$20–$100 - 4DIY fix
Cycling thermostat
It holds the drying temperature. Check the airflow first. Repair guides say to rule out the vent and the blower before you replace it.
Fix the cycling thermostat20–45 min$5–$60 - 5Call a pro
Gas valve coils
Gas only. Heat comes and goes, and you see the igniter glow, go out and no flame follow. Gas valve coil work is for a pro.
- 6DIY fix
Blower wheel
The fan that pulls air through the drum. A broken or lint-packed blower wheel moves less air, like a clogged vent.
Fix the blower45 min–2 hr$10–$60
What's happening
What your dryer is doing
A dryer works by pushing warm air through the tumbling clothes and out the vent. The air carries the water away. If the air cannot get out quickly, the drum fills with warm, damp air and the clothes stop drying.
That is why fire safety agencies say to clean the vent whenever drying times start to creep up. The same lint that slows drying is what feeds dryer fires.
The other half of the story is the load itself. A packed drum or soaking-wet clothes take longer, whatever shape the dryer is in.
If the air comes out cold, not just slowly, see dryer runs but won't heat instead.
Know your limits
When to call a pro
Stop and call a pro if
- You smell gas near a gas dryer. Leave the house and call your gas utility from outside.
- You smell burning, or the dryer cabinet or clothes feel very hot. Stop using it until it has been checked.
- Drying stays slow after you clean the lint screen and the vent, and the loads are a normal size.
- The vent runs to the roof, is very long, or is hidden in a wall you cannot reach. A vent cleaning service can clear it.
- Gas dryer: the igniter glows, goes out, and no flame follows.
FAQ
Common questions
Why does my dryer take two cycles to dry?
Usually because the air cannot get out. A clogged lint screen, lint in the duct, a crushed hose behind the dryer or a stuck outside flap all slow drying. Big or very wet loads add to it.
Is a slow dryer dangerous?
It can be. The lint that slows the airflow is also what catches fire, and fire safety groups say longer drying is the signal to clean the vent. Clean the exhaust vent before you run many more loads.
Does the vent length matter?
Yes. A long run with many bends slows the air, and every dryer maker sets a maximum length for its dryers. Check your installation instructions. Keep the hose behind the dryer short and free of kinks.
Do dryer sheets slow down drying?
They can, a little at a time. Their residue builds up on the lint screen mesh and blocks air. Wash the screen with warm soapy water every few months and see whether water runs through it.
Related
Keep going
- SymptomDryer runs but won't heatThe drum tumbles but the air stays cold. On an electric dryer, start with the breaker and the thermal fuse. On a gas dryer, start with the gas shutoff and watch the igniter.Open guide
- SymptomDryer shuts off earlyThe cycle ends, or the dryer stops mid-cycle, and the clothes are still damp. On gas and electric dryers, the usual causes are a blocked vent making it overheat, a coated moisture sensor, or a door that will not stay shut.Open guide
- Dryer partExhaust vent and ductThe exhaust duct carries hot, damp air and lint from the back of the dryer to a hood outside. When lint packs into it, drying slows and the dryer runs hot. Gas and electric dryers both need it cleaned about once a year.Open guide
- Dryer partLint screenThe lint screen catches fluff before it reaches the vent. A clogged or coated screen slows drying and makes the dryer run hot. Gas and electric dryers both have one, and cleaning it takes a minute.Open guide
- Dryer partBlower wheelThe blower wheel is the fan that pulls air through the drum and pushes it out the vent. A cracked, loose or lint-packed wheel means slow drying and odd noises. Gas and electric dryers both have one.Open guide
- Dryer partCycling thermostatThe cycling thermostat switches the heat on and off to hold the drying temperature. Gas and electric dryers both use one. When it fails, the dryer gets no heat or runs too hot.Open guide