Garbage disposal draining slowly or backing up
A disposal can run fine and still drain badly. The clog is usually just past it, in the trap or the pipe.
Check these first
Five-minute checks, no tools
Run it with plenty of cold water
Run cold water hard, switch the disposal on, and keep the water running for a little while after the grinding stops.
Clean the trap
Turn off the wall switch and unplug the disposal. Put a bucket under the trap, loosen its nuts, and clean it out.
Is it actually spinning?
If it only hums, it is jammed, not clogged. Switch it off and free it with a hex key first.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Clogged trap or drain pipe
Grease and ground food pack the trap or the pipe past it.
- 2DIY fix
Clogged discharge elbow
Food packs into the elbow or drain line between the disposal and the trap.
Fix the discharge elbow15–30 min$3–$25 - 3DIY fix
Knockout plug still in
Only the dishwasher will not drain, after a new disposal was fitted.
Fix the dishwasher inlet10–25 min$5–$10 - 4DIY fix
Jammed or worn grinder
It grinds poorly or keeps jamming, so food passes in chunks.
Fix the unjam it5–15 min$0–$10
What's happening
What your garbage disposal is doing
Ground food leaves through the discharge elbow into the trap. Grease, starchy food and fibrous peels can build a plug there over time, especially with little water running.
If a dishwasher drains into the disposal, a clog there also stops the dishwasher draining. And a new disposal with its knockout plug still in place will not take the dishwasher's water at all.
Know your limits
When to call a pro
Stop and call a pro if
- The trap is clear and the sink still drains slowly. The clog is deeper in the drain line. Call a plumber.
- Several drains in the house are slow. The main drain line may be blocked.
FAQ
Common questions
Can I use chemical drain cleaner in a disposal?
No. Disposal makers and repair guides advise against caustic drain cleaners. They can damage the unit. Clean the trap by hand instead.
Why does my sink back up when the dishwasher drains?
Often the shared drain or the disposal is partly clogged. Clean the trap and check the dishwasher drain hose has a high loop or an air gap.
Hot or cold water when grinding?
Cold. Disposal makers say to grind with cold water. It helps keep fats solid so they wash away instead of coating the pipe. Never pour grease or fat down it.
Related
Keep going
- SymptomGarbage disposal hums but won't spinYou flip the switch and hear a hum, but no grinding. Usually the flywheel is jammed. Power off, turn it with a hex key from below, remove the object, and reset.Open guide
- SymptomGarbage disposal leakingWater under the sink, traced to the disposal. Top leaks are the sink flange. Side leaks are the discharge elbow or the dishwasher hose. Bottom leaks mean the unit has failed inside.Open guide
- Garbage disposal partDischarge elbow and gasketThe discharge elbow carries ground food out of the disposal into the drain trap. A flattened gasket or loose fastener at the disposal, or a loose slip nut at the trap, leaks. Tighten it or swap the gasket.Open guide
- Garbage disposal partDishwasher inlet and knockout plugDisposals have a small inlet on the side for the dishwasher drain hose. New units ship with a plastic plug inside it. Remove the plug, fish it out, and clamp the hose on tight.Open guide
- Garbage disposal partJammed flywheelWhen something wedges between the flywheel and the grind ring, the motor hums but cannot turn. Power it off, turn the flywheel with a hex key from below, fish out the object, and reset it.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
