WhatsBusted
3D model of a washer
Symptom

Washer won't start

Before anything else, rule out the boring stuff: power, the lid or door, and the settings. A surprising number of dead washers come back to life right there.

Check these first

Five-minute checks, no tools

  • Outlet and breaker

    Plug a lamp into the washer's outlet. If it does not light, reset the breaker or a tripped GFCI outlet nearby.

  • Child lock and delay start

    A control lock, or a delay start that is counting down, can make a washer look dead. Some washers also need Start held for a few seconds. Check the manual for how to clear them.

  • Lid or door shut properly

    Close it firmly. Check for clothing caught in the seal, and a lid strike or door hook that is broken.

  • Water turned on

    Some washers will not start a cycle, or stop with a fill error, if the supply valves are closed.

  • Power reset

    Unplug the washer for about five minutes and plug it back in. It clears many control glitches.

Likely causes

Ranked by how often they are the problem

  1. 1

    Door lock (front load)

    DIY fix

    The door will not lock, or the washer cannot confirm it is locked, so the cycle never starts.

    Fix the door lock20–40 min$20–$130
  2. 2

    Lid switch or lid lock (top load)

    DIY fix

    A worn switch or a broken lid strike means the washer never sees the lid as shut.

    Fix the lid switch20–45 min$10–$60
  3. 3

    No power at the outlet

    DIY fix

    A tripped breaker or GFCI outlet, or a damaged cord. Nothing lights up.

  4. 4

    Control board

    DIY fix

    Power at the outlet but a dead display, or buttons that do nothing after a reset.

    Fix the control board20–45 min$100–$300

What's happening

What your washer is doing

To start a cycle, the washer needs power, a Start command it accepts, and a lid or door it can confirm is shut and locked.

A top loader checks its lid switch. A front loader tries to lock its door, and if it cannot lock it, it will not fill. Many show a blinking lock light or a door code when that happens.

If the display is completely dark, the problem is before all that: the outlet, the breaker, the cord or the control board.

Know your limits

When to call a pro

Stop and call a pro if

  • The outlet has power, the washer is plugged in, and the display stays dark after a reset.
  • The breaker trips again as soon as you reset it, or you smell burning. Leave it off.
  • You see burned or melted wires at the outlet or the cord.

FAQ

Common questions

Why does my washer turn on but not start?

Usually the lid or door is not confirmed shut, or a child lock or delay start is set. Check those, then the door lock or lid switch.

What does a blinking lock light mean?

Most often the washer tried to lock the lid or door and could not. Close it firmly and try again. If it keeps blinking, see door won't lock.

Can a power surge kill a washer?

It can damage the control board. Try a power reset first, then check the outlet and the breaker.

Related

Keep going

Get the next fix before it breaks

A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.

We send it with Kit. Privacy