WhatsBusted
3D model of a washer
Symptom

Washer door won't lock, or won't unlock

A front loader will not do anything until its door is locked, and will not let go until the drum has stopped and the water is out. When that goes wrong, the lock is the usual cause.

Check these first

Five-minute checks, no tools

  • Close it cleanly

    Check no clothing is caught in the seal, then close the door or lid firmly.

  • Check the door hook or lid strike

    A cracked, bent or missing hook cannot be locked, even by a good lock.

  • Drain any water

    If the door will not open and water is inside, drain it through the pump filter. The washer keeps the door locked while it is full.

  • Power reset

    Unplug for about five minutes and plug back in. A reset clears many lock errors.

Likely causes

Ranked by how often they are the problem

  1. 1

    Door lock assembly

    DIY fix

    A worn lock switch or a failed lock motor. It will not lock, will not report locked, or will not release.

    Fix the door lock20–40 min$20–$130
  2. 2

    Broken door hook

    DIY fix

    The hook on the door is cracked or bent and cannot catch the lock.

  3. 3

    Water left in the drum

    DIY fix

    The door stays locked after the cycle because the washer has not drained. Clean the pump filter.

    Fix the drain pump30 min–1.3 hr$20–$100
  4. 4

    Lid lock (top load)

    DIY fix

    On top loaders with a lid lock, the same symptoms come from the lid lock assembly.

    Fix the lid switch20–45 min$10–$60
  5. 5

    Control board

    DIY fix

    A new lock does not fix it and the wiring checks out.

    Fix the control board20–45 min$100–$300

What's happening

What your washer is doing

When you press Start on a front loader, the door lock clicks a pin into the door's hook and reports back that it is locked. Only then does the washer fill.

At the end, the control releases the lock once the drum has stopped and the water is out. If water is still inside, it keeps the door locked on purpose.

Many newer top loaders also lock their lid during spin, so the same logic applies to them.

Know your limits

When to call a pro

Stop and call a pro if

  • The door is locked with a full drum and you cannot drain it.
  • A new lock and a good door hook do not fix it.
  • The door hinge is bent and the door no longer lines up with the lock.

FAQ

Common questions

How long should a washer door stay locked after a cycle?

Usually only a short time. Some washers take up to about five minutes to finish draining and unlock. If it stays locked much longer with no water inside, check the child lock, try a power reset, then look at the door lock.

Can I force a locked washer door open?

Do not pull it hard. You can break the hook and the lock. Drain the water first and try a reset. Then use your manual's release method, or unplug the washer and reach the lock from the top panel.

Why does my washer click but not lock?

The lock is trying but not latching or not reporting back. A worn lock or a damaged door hook is the usual reason.

Related

Keep going

Get the next fix before it breaks

A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.

We send it with Kit. Privacy