Washer won't drain
Water sitting in the tub at the end of a cycle is one of the most common washer calls, and one of the most fixable. Start at the cheap end.
Check these first
Five-minute checks, no tools
Clean the pump filter
On a front loader, open the small door at the bottom front, drain into a pan, and clean the filter. This fixes a lot of drain problems.
Check the drain hose
Pull the washer out and look for a kink or a crushed spot in the drain hose, especially where it bends behind the washer.
Check the house drain
Pull the hose out of the standpipe or sink and pour a bucket of water down it. If it backs up, the house drain is clogged, not the washer.
Reset and retry
Unplug the washer for about five minutes, then run a drain and spin, or a rinse and spin, and listen at the lower front.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Clogged pump filter or jammed pump
Lint, coins, hair ties or a sock block the filter or jam the pump impeller. The pump may hum while no water moves.
Fix the drain pump30 min–1.3 hr$20–$100 - 2DIY fix
Kinked or clogged drain hose
A hose crushed behind the washer, or packed with lint, lets the pump run with little water getting out.
- 3DIY fix
Failed drain pump motor
The pump stays silent, or tests open on a meter. Replace the pump.
Fix the drain pump30 min–1.3 hr$20–$100 - 4DIY fix
Lid switch or door lock
On many washers the lid or door has to be confirmed shut and locked before it drains and spins.
Fix the lid switch20–45 min$10–$60 - 5DIY fix
Control board
The pump tests good but never gets power. Rule everything else out first.
Fix the control board20–45 min$100–$300
What's happening
What your washer is doing
At the end of each wash and rinse, the control switches on the drain pump. It pushes the water through the pump filter, if there is one, and up the drain hose into your standpipe or sink.
Anything that blocks that path stops the drain: lint and coins in the filter, a sock in the pump, a kinked or clogged hose, or a blocked house drain. If the pump motor has died, nothing moves at all.
Many washers also refuse to spin until the tub is empty, so a drain problem often shows up as a spin problem.
Know your limits
When to call a pro
Stop and call a pro if
- The standpipe or sink backs up when you pour water in. The house drain is clogged. Call a plumber.
- The pump runs, the filter and hoses are clear, and it still will not drain.
- You cannot get the water out of a full tub safely.
FAQ
Common questions
How do I drain a washer that is full of water?
Front loader: drain it through the pump filter into a shallow pan, a little at a time, closing the filter between pans. Top loader: bail it out, or lower the drain hose into a bucket below the tub.
Does a top loader have a pump filter?
Most do not have one you can reach. Check the drain hose and the pump instead.
Why does my washer drain but leave clothes soaking?
A slow or partial drain can leave enough water that the washer will not spin fast. See washer won't spin.
Related
Keep going
- SymptomWasher won't spinThe clothes come out soaking, or the washer agitates but never spins. Check drainage, the lid switch or door lock, and the load first, then the belt or motor coupler.Open guide
- SymptomWasher leaking waterA puddle under or behind the washer. Front leaks are usually the door seal or the pump filter. Back leaks are usually the fill hoses or the inlet valve. Find the spot first.Open guide
- Washer partDrain pumpThe drain pump pushes the water out at the end of each wash and rinse. Clean the filter first. If it still will not drain, test the pump and swap it.Open guide
- Washer partFill hosesFill hoses carry water from the wall valves to the washer and are under pressure all the time. Several washer makers say to replace them every five years. Here is how to check and swap them.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy
