Heat pump water heater noisy? Normal hum or a problem
A heat pump water heater is never silent while it heats. A soft, steady hum is normal. Rattles, scrapes and knocks are not, and most start with something simple.
Check these first
Five-minute checks, no tools
Only while it heats?
Listen when the heat pump is running and again once the tank is hot. A soft hum only while heating is normal. A noise that is there all the time, or a knock or scrape, is worth checking.
Air filter clean
Slide out the air filter on the top of the unit. If it is coated in dust, vacuum or wash it as the manual says, let it dry, and put it back. See the [air filter guide](/water-heater/heat-pump-air-filter).
Air inlet and outlet clear
Look at the grilles on the top housing. Move boxes, laundry or anything else away, and pick out leaves or debris you can see without opening the housing.
Level and solid
Check that the heater sits level and does not rock. A unit on a hollow or springy floor can pass hum and buzz into the house.
Try electric mode
Switch to electric-only mode for a moment. If the noise stops, it is the heat pump side. Switch back afterward, since electric mode uses more energy.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Clogged air filter
The fan sounds strained or louder than it used to, and the filter is dusty. A dirty filter restricts airflow, so the unit works harder and loses efficiency.
Fix the air filter10–30 min$0 - 2DIY fix
Debris or a loose part at the fan
A ticking, scraping or rattling that comes and goes with the fan. Debris that got past the grille, a loose blade or a shroud touching the blades can all do it. With the breaker off and the power confirmed off with a tester, look under the top cover as the fan motor guide shows.
Fix the evaporator fan45 min–1.5 hr$200–$700 - 3DIY fix
Unit not level or on a resonant floor
A buzz or drone you hear through the floor or walls more than at the heater. A tank that rocks, or a hollow floor, carries the vibration. Level the unit, or ask the installer to check the mounting.
- 4DIY fix
Worn fan motor
A growl, whine or grinding from the fan even with a clean filter and nothing touching the blades, or a fan fault code on the display. The fan motor may be failing, and it can be replaced.
Fix the evaporator fan45 min–1.5 hr$200–$700 - 5Call a pro
Compressor noise
A knock, clatter or loud buzz that is not the fan. Loose compressor mounts or a failing compressor can cause it. The compressor is part of the sealed refrigerant system, so this is a pro job.
What's happening
What your water heater is doing
A heat pump water heater has a fan and a compressor in the housing on top. While the heat pump is heating water, the fan pulls room air through a filter and across a coil. A steady hum, much like a microwave vent fan, is normal, and it stops when the tank is hot.
In electric-only mode the heat pump and fan do not run, so the heater should be quiet. If the noise stops when you switch to electric mode, it is coming from the heat pump side.
Noise that is new or getting louder usually comes from the fan: a clogged filter making it work harder, a leaf or bit of debris hitting the blades, a loose blade or shroud, or a fan motor wearing out.
Some noise is the setting, not the heater. A unit that is not level, or stands on a floor that resonates, can hum or buzz through the house. A knock or grinding from the compressor is for a pro.
Know your limits
When to call a pro
Stop and call a pro if
- You hear knocking or clattering from the compressor.
- The display shows a fan or heat pump fault after you have cleaned the filter.
- The heater is new and much louder than its spec sheet says. Call the installer or the manufacturer first, since it may be a warranty fix.
- You are not comfortable working near the fan with the cover off, even with the power off.
FAQ
Common questions
How loud should a heat pump water heater be?
While the heat pump runs, a steady fan hum about like a microwave vent fan is normal. It should stop once the water is hot. Knocking, grinding or rattling is not normal.
Why did my heat pump water heater get louder?
A clogged air filter is the first thing to check, because it makes the fan work harder. After that, look for debris or a loose part at the fan, and make sure the unit has not shifted off level.
Can I make a heat pump water heater quieter?
Keep the filter clean, keep the air inlet clear, and make sure it sits level on a solid floor. If you need it quiet for a while, electric-only mode turns off the fan and compressor, at the cost of higher energy use.
Related
Keep going
- SymptomHeat pump water heater slow to recoverHeat pump water heaters only. The hot water runs out and takes a long time to come back. Check the operating mode, the air filter, the room's size and temperature, and the backup heating elements.Open guide
- SymptomHeat pump water heater leaking condensateHeat pump water heaters only. Water around the base, dripping down the side, or a condensate alarm on the display. Usually the condensate drain line is clogged, kinked or not sloped. Rule out the tank's own valves and fittings too.Open guide
- SymptomWater heater rumbling or poppingA rumbling, popping or crackling tank usually means sediment has built up on the bottom. On electric heaters, scale on the lower element can do it too. Flushing the tank is the usual fix.Open guide
- Water heater partHeat pump air filterHeat pump (hybrid) water heaters only. A washable filter cleans the room air before the fan pulls it across the evaporator coil. When it clogs, the heat pump works harder, the filter light comes on, and many units fall back to the electric elements.Open guide
- Water heater partHeat pump evaporator fan motorHeat pump (hybrid) water heaters only. The evaporator fan in the top section pulls room air across the coil so the heat pump can take heat from it. When the fan fails, the heat pump cannot run. Most of these heaters run on 240 V, so the power goes off and stays off, verified with a tester.Open guide
- Water heater partHeat pump sealed systemHeat pump (hybrid) water heaters only. The sealed system is the closed refrigerant loop that moves heat from the room air into the tank: the evaporator coil, the compressor and the tubing. A leak or a failed compressor stops the heat pump, and any repair means opening the loop, which is certified work.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy