Laundry center dryer takes too long to dry
The dryer heats and tumbles, it just cannot get the water out fast enough. Most of the time the fix is about airflow, and airflow is cheap to fix.
Check these first
Five-minute checks, no tools
Lint screen clean and open
Clear the [lint screen](/dryer/lint-screen) before every load. If residue coats the mesh, scrub both sides with a nylon brush, hot water and a little liquid detergent.
Strong air at the outside hood
With the dryer running, go outside. The flap should open and the air should feel strong and warm. Weak air means a restriction.
Duct not crushed behind the cabinet
Unplug the laundry center, pull it out carefully and look behind it. The duct should be round, with no kinks, pinches or flat spots.
Load not too big or too wet
Clothes need room to tumble, and a nearly empty drum dries slowly too. Make sure the washer's spin finished so clothes are not dripping.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Clogged or crushed vent duct
Lint packed in the duct, a crushed duct behind the cabinet, a long run with many bends, or a stuck outside flap. Weak air outside is the giveaway. See the exhaust vent guide.
- 2DIY fix
Load too big or too wet
An overloaded drum cannot tumble the clothes, and clothes that come out of the washer very wet carry extra water. If the washer leaves them dripping, see washer won't spin.
- 3DIY fix
Lint screen clogged
A full screen, or one coated in softener residue, chokes the airflow. Clear it every load and wash it now and then. See the lint screen guide.
- 4DIY fix
Cycling thermostat
It holds the drying temperature. Check the airflow first: repair guides say to rule out the vent and the blower before you replace it. See the cycling thermostat guide.
- 5DIY fix
Blower wheel
The fan that pulls air through the drum. A broken or lint-packed blower wheel moves less air, like a clogged vent. See the blower wheel guide.
What's happening
What your laundry center is doing
The dryer on top pushes warm air through the tumbling clothes and out the vent. The air carries the water away. If the air cannot get out quickly, the drum fills with warm, damp air and the clothes stop drying.
A lint clog anywhere in the vent path makes the dryer work harder and take longer, and a bad one can make it overheat and shut down. Fire safety agencies say to clean the vent whenever drying times creep up. The exhaust vent guide shows how.
The load matters as well. An overloaded or nearly empty drum dries more slowly, and clothes that leave the washer below dripping wet carry extra water. If they do, see washer won't spin.
Unplug the laundry center before you pull it out or reach behind it, and unplug every cord if it has two.
Know your limits
When to call a pro
Stop and call a pro if
- You smell burning, or the dryer shuts itself off hot. Stop using it until it has been checked.
- Drying stays slow after you clean the lint screen and the vent, and the loads are a normal size.
- The vent runs to the roof, is very long, or is hidden in a wall you cannot reach. A vent cleaning service can clear it.
FAQ
Common questions
Why does my laundry center dryer take two cycles?
Usually because the air cannot get out. A clogged lint screen, lint in the duct, a crushed hose behind the cabinet or a stuck outside flap all slow drying. Big or very wet loads add to it.
Is a slow dryer dangerous?
It can be. The lint that slows the airflow is also what catches fire, and a bad clog can make the dryer overheat. Fire safety groups say longer drying is the signal to clean the vent. Clean the exhaust vent before you run many more loads.
Does the vent length matter?
Yes. A long run with many elbows slows the air and collects more lint. Your laundry center's installation instructions give the longest vent run it allows. Keep the duct behind the cabinet short and free of kinks.
Related
Keep going
- SymptomLaundry center dryer runs but won't heatElectric laundry centers only. The dryer on top tumbles but the air stays cold. Start with the breaker and the lint path, then test the thermal fuse, the heating element and the thermostats.Open guide
- SymptomLaundry center washer won't spinThe clothes come out of the washer below soaking, or it agitates but never spins. Check the spin setting, the drain, the lid switch and the load first, then the motor coupler or belt.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy