Laundry center washer won't spin
A washer that will not spin is usually protecting itself. Either the water is not out, the lid is not confirmed shut, or something in the drive has let go.
Check these first
Five-minute checks, no tools
Spin setting not on low or off
Check that a low spin or no spin option is not selected, then run a rinse and spin.
Is the water out?
If water is left in the tub, fix the drain first. See [washer won't drain](/laundry-center/symptoms/washer-wont-drain).
Lid fully shut
Close the lid firmly and check that the lid strike, the tab that presses the switch, is not broken or bent.
Rebalance the load
Spread a wet, lumpy or tightly packed load evenly around the basket, and go easy on detergent. Then try a rinse and spin.
Reset the power
Unplug the laundry center for about five minutes, plug it back in and try a spin-only cycle.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Water not draining
The washer will not spin with water in the tub. A jammed or failed pump, or a kinked hose, stops the spin too. See washer won't drain and the drain pump guide.
- 2DIY fix
Lid switch or lid lock
The washer fills and agitates, then skips the spin, because it never sees the lid as shut, or cannot lock it. See the lid switch guide.
- 3DIY fix
Unbalanced load or too many suds
A load bunched to one side, or a tub full of suds, makes the washer slow or skip the spin to protect itself. Spread the load out and measure the detergent. If it shakes hard with a normal load, see washer shaking and banging.
- 4DIY fix
Motor coupler (direct drive)
On direct-drive models: it fills and drains, the motor runs, but nothing agitates or spins. The coupler has broken. See the motor coupler guide.
- 5DIY fix
Drive belt (belt drive)
On belt-drive models: the motor runs but the basket does not turn, because the belt is broken, worn or loose. A laundry center's washer is a top loader, and its belt is reached and fitted differently from a front loader's, so follow your laundry center's service manual to reach, check and replace it.
- 6DIY fix
Drive motor
Silent, or humming with nothing turning. Motors fail less often than the parts around them, so rule those out first. See the drive motor guide.
- 7DIY fix
Timer or control board
Every part tests good and still does not get power. See the control board guide.
What's happening
What your laundry center is doing
Before it spins, the washer needs the tub drained, the lid confirmed shut (and on some models locked), and a load balanced enough to spin. If any of those fail, it skips or stops the spin.
Settings and suds matter too. A low spin or no spin option, or too much detergent, can leave the clothes wet with nothing broken at all.
If all of that checks out and the motor runs while the basket stays still, the drive has a problem. Some laundry centers are direct drive, with a motor coupler that breaks on purpose to protect the motor. Others use a drive belt. The washer won't spin guide covers the same causes on full-size washers.
Before you open anything, unplug the laundry center, every cord if it has two, and turn off both water taps. Access panels differ from a full-size washer, so follow your laundry center's service manual or tech sheet for which panel to remove.
Know your limits
When to call a pro
Stop and call a pro if
- The basket will not turn by hand, or grinds, with the laundry center unplugged.
- You smell burning or see smoke. Unplug it and leave it unplugged.
- The drain, the lid switch, the coupler or belt and the load all check out.
- You cannot find the service manual or tech sheet for your laundry center and are not sure which panel to remove.
FAQ
Common questions
Why does my laundry center washer agitate but not spin?
The lid switch is the first suspect, especially if the lid strike is fine. On some washers it sits in the spin circuit only, so the washer fills and agitates but never spins. Next is a drain problem, then the drive.
Can I bypass the lid switch to test it?
No. Test the switch with a meter, with the laundry center unplugged. Bypassing it lets the basket spin while your hands can reach in.
Is my laundry center washer direct drive or belt drive?
Laundry centers come both ways. The parts list or service manual for your model number shows a motor coupler or a drive belt. A coupler model can follow the motor coupler guide. On a belt model, follow the service manual: our washer belt guide is written for front loaders, whose belt is reached and fitted from the back.
Related
Keep going
- SymptomLaundry center washer won't drainThe washer below stops with water in the tub, or the clothes come out soaking. A kinked drain hose, a sock in the pump or hose, a blocked house drain or a failed pump causes most of it.Open guide
- SymptomLaundry center dryer takes too long to dryLoads need two cycles, or come out damp. On a laundry center, as on any vented dryer, the usual cause is restricted airflow: a clogged lint screen, a blocked vent or a crushed duct. Load size matters too.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy