Laundry center dryer runs but the drum won't turn
You can hear the motor, but the clothes just sit there. On a laundry center, as on a full-size dryer, that is usually the belt, and a belt is a cheap part.
Check these first
Five-minute checks, no tools
Turn the drum by hand
Unplug the laundry center, open the dryer door and turn the drum with your hand. A good belt gives steady drag. If the drum spins with almost no resistance, the belt is likely broken or off.
Listen for the motor
Plug back in and start a dryer cycle with the door shut. A steady motor sound with a still drum points to the belt or idler. A hum while the motor does not turn points to the motor, or to something jamming the drum.
Empty the drum
Take everything out and try again with an empty drum. That rules out something jammed in the drum.
Likely causes
Ranked by how often they are the problem
- 1DIY fix
Broken or slipped drum belt
The most common reason the drum will not turn. The motor runs, and the drum spins freely by hand. See the drum belt guide.
- 2DIY fix
Idler pulley
The belt is intact but loose, or keeps coming off. A seized idler bearing or a broken spring arm loses the belt's tension. See the idler pulley guide.
- 3DIY fix
Worn drum support rollers
The drum is hard to turn by hand or wobbles once the belt is off. Worn rollers drag on the drum, and the extra load can make the belt slip or snap. See the drum support rollers guide.
- 4DIY fix
Drive motor
The belt and drum check out, but the motor hums and will not turn, or is too weak to turn the drum. See the drive motor guide.
What's happening
What your laundry center is doing
One motor does two jobs. One end of its shaft turns a long, thin belt wrapped around the drum. The other end spins the blower wheel. A spring-loaded idler pulley keeps the belt tight.
If the motor runs but the drum stays still, the link between them is broken. Most often the belt has snapped or slipped off. The dryer won't tumble guide walks through the same checks on a full-size dryer.
The belt can also come off because the idler pulley seized, or the drum can drag because its support rollers are worn. Check all three while the belt is off.
Unplug the laundry center before you touch the drum or remove a panel, and unplug every cord if it has two. Access panels differ from a full-size dryer, so follow your laundry center's service manual or tech sheet for which panel to remove.
Know your limits
When to call a pro
Stop and call a pro if
- You smell burning or see smoke from the dryer. Unplug the laundry center and do not use it until it is checked.
- The motor hums but will not turn even with the belt off.
- A new belt keeps coming off or wearing out quickly.
- You are not comfortable taking off the dryer's panels, or cannot find the service manual for your laundry center.
FAQ
Common questions
How can I tell if the dryer belt is broken?
Unplug the laundry center, open the dryer door and turn the drum by hand. With a good belt you feel steady resistance, because you are also turning the motor. If the drum spins easily and keeps coasting, the belt has broken or slipped off.
Is a laundry center dryer belt the same as a full-size dryer belt?
It does the same job and is checked the same way, so the drum belt guide applies. The belt length and the way in differ by model. Order the belt by your laundry center's model number, and follow its service manual or tech sheet for which panel to remove.
Should I replace the idler and rollers with the belt?
Check them while the dryer is open. The idler should spin freely and smoothly, and the drum should turn without wobbling once the belt is off. Many repairers replace all three together, since worn rollers or a stiff idler shorten the life of a new belt.
Related
Keep going
- SymptomLaundry center dryer runs but won't heatElectric laundry centers only. The dryer on top tumbles but the air stays cold. Start with the breaker and the lint path, then test the thermal fuse, the heating element and the thermostats.Open guide
- SymptomLaundry center dryer takes too long to dryLoads need two cycles, or come out damp. On a laundry center, as on any vented dryer, the usual cause is restricted airflow: a clogged lint screen, a blocked vent or a crushed duct. Load size matters too.Open guide
Get the next fix before it breaks
A short email when the seasons turn: filters to change, detector batteries to check, and new repair guides. No spam, unsubscribe any time.
We send it with Kit. Privacy